User manual SAMSUNG UN40C6900VM

[. . . ] ENTERE button. Changing the Picture Mode Your TV has four preset Picture Modes with factory adjusted settings, each designed to give you an excellent picture under specific conditions. The Picture Modes are listed and described in the table below: Mode Dynamic Standard Natural Movie s Rear 1 Step 2: Install the Batteries into the Remote To install batteries into your remote control, follow these steps: 1. Lift the cover on the back of the remote upward as shown in the figure to the right. Install two AAA batteries. When you turn on your TV for the first time, it automatically launches the Plug & Play function. [. . . ] Menu Language : English Español Français U Move E Enter To change the Picture Mode, follow these steps: 1. Turn on your TV, press the TOOLS button on your remote. Using the or on your remote, select Picture Mode. On the Picture Mode menu, use the or on your remote to select the Picture Mode you want. Press the EXIT button to exit the menu. press the ENTERE button. If you select Store Demo, the TV will reset your picture and audio settings every 30 minutes. Cable or Auto, you must select Channel Source to same type as your cable system type. After selecting source, select Search; then press the ENTERE button on your remote. 3. Replace the cover. 3 Select Antenna Source and Channel Source. If Antenna Source is VHF/UHF Antenna Step 3: Connect Power and Antenna or Cable Antenna Cable (Not Supplied) Setting the Clock 16:9 Wide screen 4:3 Standard screen Wide Fit Most cable systems are Standard(STD) systems, If you are not sure about what kind of cable system you have, contact your cable company. If your TV is attached to a cable or satellite box, skip Steps 3 through 5. (Using the remote control with this button set to off will reduce the battery usage time. ) PRE-CH Network Connection - Wired There are two main ways to connect your TV to your network using cable, depending on your network setup. They are illustrated below: The Modem Port on the Wall External Modem (ADSL / VDSL / Cable TV) TV Rear Panel LAN Cable (Not Supplied) or Returns to the previous channel. Changes channels. Modem Cable (Not Supplied) LAN Cable (Not Supplied) FAV. CH INFO Displays the channel list on the screen. Displays Favorite Channel Lists on the screen. Selects the on-screen menu items and changes the values seen on the menu. SLEEP: Automatically shuts off the TV at a preset time. MTS: Press to choose stereo, mono or Separate Audio Program (SAP broadcast). P. MODE: Press to select the picture mode. CC: Controls the caption decoder. LAN Cable (Not Supplied) The LAN Port on the Wall TV Rear Panel Samsung's Wireless LAN adapter supports the IEEE 802. 11A, IEEE 802. 11B, IEEE 802. 11G, and IEEE 802. 11N wireless communication protocols. For your TV to connect to your network, the wireless router or modem you use must also support one of these protocols. The fastest of these protocols is IEEE 802. 11N. [. . . ] Set the Network Type to Wired if it is not already set to Wired. On the Network Setup menu, set Internet Protocol Setup and DNS to Auto. Auto acquires and enters the necessary internet values automatically. Select Network Test to check Internet connectivity. S. MODE P. MODE SLEEP P. SIZE MTS CC Use these buttons in Media Play (USB) and Anynet+ (HDMI-CEC) modes. [. . . ]