User manual SAMSUNG VAC9013RP

[. . . ] such damage is not covered by the warranty. Never use the vacuum cleaner without its filters. 17 Attach the telescopic tube to the hose handle and the floor nozzle (certain models have a lock button that must be pressed before the hose and telescopic tube can be pulled apart). If you have a vacuum cleaner with remote control, make sure that the connector is pressed in completely. [. . . ] Hard floors and carpets: * The Max In, Max In Turbo and Max In motorised floor nozzles (7) detect the type of surface being vacuumed. * The nozzle with the pedal is set to the type of surface to be vacuumed: Position 1 for carpets (23) and position 2 for hard floors (24). * Use normal setting of floor nozzle for carpets (25) * Use the brush setting of floor nozzle for hard floors (26) Crevices, corners, etc. Max In, Max In Turbo and Max In motorised floor nozzles, are ideal for both hard floors and carpets. The Max In motorized nozzle receives power via the tube and hose, and no additional electrical connections are needed. a blue light on the nozzle indicates that the brush roller is turning. If anything should become lodged in the brush roller, the light turns off. 27 When you pause during cleaning, the tube can be attached to the rear of the vacuum cleaner. 28 When storing, the vacuum cleaner can be placed on end and the tube attached at the bottom of the vacuum cleaner. How to use the telescopic tube 29 Extend or shorten the telescopic tube by pushing the release button towards the nozzle and simultaneously adjusting the length of the telescopic tube. There is a catch at both ends of the telescopic tube. Pull out the power plug and allow the vacuum cleaner to cool down for 20­30 minutes. 43 It is sometimes possible to clear the hose by "massaging" it. However, be careful in case the obstruction has been caused by glass or needles caught inside the hose. Note: The warranty does not cover any damage to hoses caused by cleaning them. If something gets stuck in the vacuum cleaner: 44 Turn off the vacuum cleaner and open the cover at the front of the unit by lifting the release catch. 45 Lift out the filter holder and the filters. 46 Lift the cover between the filter wells and remove anything that may have got stuck. also check the bottoms of the filter wells for foreign objects. 47 Refit the cover under the catches and close it by pressing down. Put the filter holder back in place and close the vacuum cleaner cover. 48 The Max In and the carpet/floor nozzles should be cleaned frequently to avoid losing suction power. [. . . ] The dust container can be thoroughly cleaned when emptying. 54/55 Remove the "cone" on the side with your finger by pulling it up and straight on. The dust container and the "cone" can now be wiped off or cleaned. If you use water, make sure that the cartridge is dry before you put it back. [. . . ]