User manual SAMSUNG VC-8932ET INTRODUCTION

[. . . ] Keep the vacuum cleaner away from stoves and other heat sources. Heat can deform and discolour the plastic parts of the unit. [. . . ] AUTO MODE, in this case, increases the power automatically for sufficient suction. If you want to go back to the normal control type, just press "+" or "-" buttons. Using Exbug Elimination System (DEPENDING ON MODEL) It is best to use the Mite Killing cycle immediately after you have finished your cleaning. Ensure machine is plugged in and the power point is switched on. Disconnect the hose from the cleaner by pressing in the two buttons on the hose end and lift the hose out. Close the hose connection cover on the top of the cleaner until tone is heard. Switch the cleaner on and the cleaner will run. The Mite Killer cycle will automatically stop when complete. Unplug the cleaner, rewind the cord, open the hoses connection cover and re-connect the hose. Your cleaner can be used immediately after the Mite Killer cycle stop or by interrupting the cycle. To do this, switch cleaner off, open the hose connection cover and re-connect the hose. 5 DJ68-00093N 5/30/02 9:20 AM Page 7 USING THE ACCESSORIES Open the tool storage cover upwards. CREVICE DUSTING UPHOLSTERY Crevice tool for radiators, crevices, corners, between cushions. Dusting brush for furniture, shelves, books, etc. Upholstery brush for cushions and drapery. PARK POSITION Located in the top rear side of the vacuum cleaner, there is a nozzle support that can be used to park the nozzle during pauses in cleaning TRANSPORTING AND STORING THE VACUUM CLEANER For easy storage and transportation, this vacuum cleaner has a clip system built into body, which will keep the wand, hose and nozzle in an upright position. 6 DJ68-00093N 5/30/02 9:20 AM Page 8 REPLACING THE DUST BAG 1) To open the dust cover of the dust bag compartment, press the clamper upwards(the clamper is located at the front of the dust cover). 2) Remove the dust bag from the cleaner 3) After removing the used dust bag, insert the cardboard bag collar of the new dust bag into its original position. 4) Press the dust cover down gently until the clamper relocks. NOTE : Used dust bags can be sealed by removing the film from the paper and sticking over the suction opening. FOR CLOTH FILTER BAG After using, if the cloth filter bag is full of dust, clean the cloth filter bag and use it again. DUST-FULL INDICATOR If the "Dust-Full" indicator switch changes to "RED" while you are cleaning, the dust bag is full and must be replaced. NOTE : If the "Dust-Full" indicator continues to display "RED" even after changing the dust bag, turn the cleaner off and check whether the hose, tube or nozzle is clogged. 7 DJ68-00093N 5/30/02 9:20 AM Page 9 CYCLONIC FILTER (ONLY CYCLONIC FILTER TYPES) You can use a dust bag in your cleaner for a long time thanks to the Cyclonic Filter system and it maintain the maximum cleaning efficiency. The larger particle of dust filtered from Cyclonic Filter remain in Dust Barrel when suctioned air and dust revolves in the Cyclonic Filter. So the dust bag contains only smaller ones. [. . . ] FOR UNIVERSAL BRUSH Use the floor nozzle for cleaning all surfaces. NOTE: For optimum efficiency, clean floor brush with crevice tool. TRANSPARENT TUBE Transparent tube prevent the tube and hose from being clogged by obstacle like as socks and clothes. Remove the alien substance with a stick from it. [. . . ]