User manual SAMSUNG VC-U316 INTRODUCTION

[. . . ] To unplug, grasp the plug, not the cord. ·Do not handle plug or appliance with wet hands. ·Do not put any object into vacuum openings. Do not operate with any opening blocked: Keep free of dust, lint, hair and anything that may reduce air flow. [. . . ] ·Use upholstery side for curtains, draperies, cushions, fabrics. Crevice tool: Use in corners, on stairs, baseboards, and behind furniture. Extension Wand: Use with desired attachments and narrow wand for a longer reach. 2-6 2-7 Carpet height adjustment Carpet and rug cleaning takes place at the nozzle (A). When it is necessary to raise and lower the nozzle for various carpet pile heights, rotate the nozzle control knob (B) to the desired setting. 2-8 Cleaning lightweight flexible rugs Stand on one end of rug and move cleaner toward other end or edge. Before reaching edge, push down on handle. This will lift up the nozzle(front of cleaner)and will prevent rug from clinging to cleaner. Continue to lift front of cleaner so that when you have reached the edge, it is completely off the rug. Move cleaner back to start again, lower front of cleaner, and use only forward strokes. For maximum cleaning performance, The following carpet height settings are recommended: ·Lowest setting: for all types of carpet ·Higher settings: for very deep pile carpet where easier pushing effort is desired, while maintaining good cleaning performance. Note: If the cleaner is difficult to push, rotate knob to the next higher setting. 2-9 Power control (some models only) To change the power level of the vacuum cleaner, rotate the knob. 3 DJ68-00075A 2001. 7. 52:24PM 5 Maintenance Familiarize yourself with these home maintenance tasks as proper use and care of your cleaner will ensure continued cleaning effectiveness. When to replace the Dust bag Check the dust bag from time to time. Change the dust bag when dirt reaches the dotted line. If more dirt than this accumulates, your cleaner will not operate effectively. Note: All new carpet has loose fibers which can fill the bag quickly while vacuuming. Replacing Dust Bag Disconnect cleaner from electrical outlet. 3-1 3-2 3-3 Pull the bag door outward to open. Set bag door aside. Removing and installing filter bag Grasp dust bag collar (A) and pull collar from tube (B). Note: Do not clean out old dust bag and reuse. Tuck in dust bag. Replacing bag door Reposition bag door by placing tab on bottom of door into opening (C). Press top of door to snap securely shut. 3-6 Cleaning secondary and final filters 3-4 3-5 How to attach filter door The filter door is designed with a "break away" feature which allows it to snap free if it is pushed open too far. To reattach, align hinges (C) of cover with slots on sides of filter area. How to clean Disconnect cleaner from electrical outlet. The secondary filter (A), located behind the grill in the bottom of bag compartment, protects the motor from dirt particles. If filter becomes dirty, pull off grill and lift out filter. Normal filter (Black) Hand wash filter in cold water with mild detergent, then air dry. [. . . ] Continue following the directions in "The belt" section to reposition belt, new agitator and bottom plate. 5 DJ68-00075A 2001. 7. 52:24PM 7 Maintenance Clearing Clogs Disconnect cleaner from electrical outlet. The hose on the back of the vacuum cleaner that carries the dirt from the nozzle to the dust bag can sometimes become clogged. If you notice a change in the sound of the vacuum motor, check for clogs. 3-14 3-15 3-16 Pull and open the suction inlet cover, and check for a clog. Disconnect the wand and check for clogs in the vacuum base, the wand and the hose. If the clog persists, turn the vacuum cleaner off and unplug it. Lift up the short hose in the base of the vacuum. [. . . ]