User manual SAMSUNG VC240

[. . . ] SyncMaster VC240 Video Conference System User Guide Information in this user guide is subject to change without prior notice for performance improvement. i Copyright The color and design may differ depending on the model, and specifications are subject to change without prior notice for performance improvement. © 2010­2011 Samsung Electronics Co. , Ltd. All rights reserved by Samsung Electronics Co. , Ltd. You are prohibited from unauthorized use or reproduction of any of the information in this user guide without prior approval from Samsung Electronics Co. , Ltd. [. . . ] 4 Select OK to save the new settings. . . 5 You are advised to check that the IP settings are valid; select Network . Test. While the test is performed, the valid items will be indicated by a 17 3. 1 Network Settings whereas the invalid items will be indicated by a . . 6 Assign the monitor a name so that it can be identified by other devices . connected to the network. 2 Select the LAN port connected to the router. . . 3 Adjust several options alternately until the connection succeeds. . Select Display Name, and enter a name. The data transmission rate and mode are determined while the monitor tries to connect to a router. Usually, the monitor is automatically connected; however, the connection attempt will sometimes fail. When the connection fails, configure the data transmission rate and mode manually as follows: 18 3. 2 Data Transmission Mode 3. 2 Data Transmission Mode You can make or receive calls using one of the following data transmission protocols: · H. 323 · Session Initiation Protocol . 3 Set Network Preference to H. 323. . H. 323 Data Transmission To make calls using the H. 323 telephone number mode (E. 164), configure the settings as follows: . 1 Press . to open the Setup screen, and select Network. . 4 If an H. 323 gatekeeper is available, select H. 323 Settings. . a) Set Gatekeeper to On. 2 Select Phone Number and enter a number. Dial by user name (alias) is available in H. 323 through the gatekeeper. . b) Fill the gatekeeper IP in the Address field. c) If data transmission fails due to firewall restrictions, set H. 460 Traversal to On, and fill the H. 460 server IP address. 5 Select OK to save the new settings. . SIP Data Transmission To make calls using the SIP user name mode, configure the settings as follows: 19 3. 2 Data Transmission Mode . 1 Press . to open the Setup screen, and go to Network. . In SIP you can use both name and number in URI for dialing. . a) Set SIP Proxy Server to On. b) Fill the Display Name, Server Address, and Password fields. 5 Select OK to save the new settings. . . 3 Set Network Preference to SIP. . H. 323 and SIP modes cannot be used at the same time. To change the current H. 323 mode to SIP, set Network Preference to SIP. NAT Traversal You can make or receive a call while being connected to ADSL or Cable router from home or office. The system will use Network Address Translation from internal IP to External IP. [. . . ] Downloading the software to the system GUI from an external local HTTP server. Please refer to upgrade document available from customer support for HTTP server setup. 1 Press . to open the Setup screen. to open the Setup screen. . 2 To view the monitor software version, select SW Version. . The monitor will restart itself after resetting. [. . . ]