User manual SAMSUNG VC-C5630V35

[. . . ] · Do not allow children to operate vacuum cleaner or use as a toy. · Close attention is necessary when used by or near children. · Use only as described in this manual. Use only manufacturer's recommended attachments. [. . . ] securing the check that the handle is fitted to the vacuum body and there's no gap between them. If there is a gap or the screw is loosened, cleaner won't turn on. Attach Handle To Dirt Cup The dirt cup assembly consists of the following parts; * Dirt Cup (A) * Dirt Cup Handle (B) 1 Unlock the dirt cup from the cleaner body. 2 Insert the dirtuntil ithandleininto the dirt cup as shown. 3 Insert the dirt cup into the cleaner body and lock. 4 B A Vacuum Cleaner Assembly Attach Vacuum Hose and Tools hooks for storage. The top hook 1 Wrap the cord aroundeasy rotates right or left for cord release. hose with two from Tighten 2 Attachthetheassembly packet. screws securely them with a screw driver. shown. 3 Snap the hose into the hose clip as NOTE: The powerfoot will not operate effectively unless the Hose is firmly attached to the base. the extend wand storage clip. crevice 4 Slidethe nook. Insert the into the tool into the insert upholstery brush into the 5 Snap in clip Dusting brush and storage as shown. 5 Operation Power Switch/Brush Roll Switch(Circuit Breaker) The power control slide switch is located on the front of the handle. This switch also allows you to control the cleaning power. 1 Plug cord into electrical outlet. ON(I), the 2 To turn cleaner onslide slidepowerpower switch up. To turn cleaner OFF(O), the switch down. The headlight turns when in use. The brush roll switch is located on the side of the cleaner body. Knob to 2 Turn Height Adjustment- For bare desired setting. Lowest Setting floors. Medium Settings - For short and medium pile carpets. Highest Setting - For plush pile carpet. NOTE : You may also adjust the setting while in the Medium position. Edge Cleaning The Edge Cleaning Feature helps the cleaner to clean edges of rugs and floors effectively, allowing suction to reach against walls and near furniture. Cleaning Tools Attachment tools can be used to clean furniture, drapes, stairs, or in corners. Place the vacuum on the floor with the handle in the upright position while using attachment tools. Do not place the vacuum on top of furniture or steps as the brushroller may cause damage. hose (with cleaning tools attached) from the rear of the vacuum tool to the wand. 2 Place desired tool on end of narrow wand. Press firmly and twist to connect the A. Dusting Brush: Use for carved furniture, table tops, books, lamps, lighting fixtures, venetian blinds, base boards, shutters and registers. Crevice tool: Use in corners, on stairs, baseboards, and behind furniture. A B 7 Operation C. [. . . ] Filter Tank pulling it from 2 The Cartridgethe cleaner. assembly can be reached by from the Cartridge Filter Tank, and the foam may be and 3 Remove the coverremovedthen hand-washed in cold water with mild detergent, air dried. 4 Reposition Filters when completely dry. WARNING: Do not operate cleaner with damp or wet filters or without all filters in place. Cartridge Filter Tank Cleaning the HEPA Media Post-Motor Filter 1 Unplug the Cleaner from electrical outlet. Media Post-Motor Filter assists in filtration air the It is door on the the cleaner. If the filter 2 ThetoHEPAroom. openlocated behind thethe filtertheandside ofprocess to return clean becomes dirty, the door, remove clean. [. . . ]