User manual SAMSUNG VP-D70

[. . . ] Faults caused by ingress of fluids may not be possible to repair. Notes regarding the battery pack - Make sure that the battery pack is fully charged before starting to record. - To preserve battery power, keep your camcorder turned off when you are not operating it. - If your camcorder is in CAM mode and it is left in STBY mode without being operated for more than 5 minutes with a tape installed, it will automatically turn itself off to protect against unnecessary battery discharge. [. . . ] Be careful when placing the camcorder under sunlight or near a window exposed to sunlight. Do not pick up the camcorder using the viewfinder. Excessive force when pulling the viewfinder out may damage it. Notes regarding `Record' or `Playback' using the LCD 1. The LCD display has been manufactured using high precision tech- nology. However, there may be tiny dots (red, blue or green in colour) that appear on the LCD display. These dots are normal and do not affect the recorded picture in any way. When you use the LCD display under direct sunlight or outdoors, it maybe difficult to see the picture clearly. If this occurs, we recommend using the viewfinder. Direct sunlight can damage the LCD monitor. Notes regarding the hand strap - To ensure a steady picture during filming, check that the hand strap is properly adjusted. Notes I I I Video inputYellow Audio input (left)-White Audio input (right)-Red S-VIDEO input Connecting to a TV which has no Audio and Video input jacks You can connect your camcorder to a TV through a VCR. Connect the camcorder and VCR with the Multi-AV cable. I The yellow plug : Video I The white plug : Audio(L) - Mono I The red plug : Audio(R) 2. Set the power switch on the camcorder to PLAYER mode. ANTENNA VCR VIDEO AUDIO(L) AUDIO(R) S-VIDEO TV A/V OUT CAMCORDER TV 4. I Set the input selector on the VCR to LINE. I Select the channel reserved for your VCR on the TV set. Camcorder 5. Play the tape back. A/V OUT Playback You can play the recorded tape in PLAYER mode. Connect a power source and set the power switch to PLAYER mode. Using the (FF) and (REW) buttons, find the first position you wish to play back. I The images you recorded will appear on the TV after a few seconds. I If a tape reaches its end while being played back, the tape will rewind automatically. [. . . ] Press the (STOP) button after 10 seconds. Notes I I Check the quality of the picture using a videocassette. If the picture quality has not improved, repeat the operation. If the problem continues, contact your local authorized service center. [. . . ]