User manual SAMSUNG VR30T80313W/WA

[. . . ] Before operating this unit, please read the instructions carefully. For the normal use of the Jet Bot's functions, the SmartThings connection is required. Accessories may differ depending on the models. Pre-motor Filter: 2 units (Inside the product: 1 unit, Spin Brush: 2 units (Inside the product: 1 unit, Install the Docking Station in a place where the floor and wall are level. [. . . ] Be careful not to put your finger into the revolving LiDAR sensor. Prevent any damage to the Jet Bot by complying with the following. - Do not clean the Jet Bot by spraying water directly onto it or use a volatile substance such as benzene, thinner, or alcohol to clean it. Do not disassemble or repair the Jet Bot. This should only be done by a certified repairman. Always keep the Obstacle Sensor Window and the Cliff Sensor Window clear. - If foreign matter accumulates, sensors may malfunction. Be careful that the LiDAR sensor is not Exposed to a direct light such as sun light, infrared light, etc. - The direct light can affect the performance When carrying the Jet Bot, be careful not to let it drop. - The impact from the drop can affect the Do not look at the transmitting part (a laser) of the revolving LiDAR sensor horizontally. Be careful not to insert a tool such as a chopstick into the revolving LiDAR sensor. Otherwise, the LiDAR sensor may work abnormally or malfunction. Before cleaning, remove objects which are less than 9 cm height and are lightly on the floor as the Jet Bot can push along them, or the objects can be caught in the Jet Bot's spin brush or driving wheels. The Jet Bot cannot vacuum clumps of dirt, so some may remain on the floor after cleaning. - Please use another cleaning tool to clean them regularly. After turning the Jet Bot off, wait for a while and then turn it on for a normal rebooting. If you washed the Dustbin and filter with water - Dustbin: Completely wipe out the water. - Filter: Completely dry it in the shade before use. Watch your fingers when attaching or detaching the filter, since they may get stuck in the Dustbin's intake. To avoid blockages by foreign matter, do not let the Jet Bot vacuum up toothpicks, cotton swabs, etc. If it is difficult to remove foreign matter from the brush, contact an authorized SAMSUNG service center. Since the brush sweeps dirt up from the floor during cleaning, foreign matter such as a thin and long thread, long hair, etc. [. . . ] The battery incorporated in this product is not user replaceable. For information on its replacement, please contact your service provider. Do not attempt to remove the battery or dispose it in a fire. Do not disassemble, crush, or puncture the battery. [. . . ]