User manual SAMSUNG WA7000A1

[. . . ] If the control panel for this washer is damaged, it must be replaced by a repair shop appointed by the manufacturer, as special purpose tools are required. q Do not operate this appliance if it is damaged, malfunctioning, partially disassembled, or has missing or broken parts, including a damaged cord or plug. q Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. q The instructions for use shall specify the maximum mass or dry cloth in kg, for which the appliance is designed. [. . . ] Press the FUNCTION SELECT button three times. Press the START/HOLD button once. Function Button BUTTON Three times RINSE ONLY Press the FUNCTION button four times. Press the START/HOLD button once. Function Button Four times SPIN ONLY Press the FUNCTION button five times. Press the START/HOLD button once. Function Button Five times RINSE AND SPIN Press the FUNCTION button six times. Rinsing and spin drying follow. Function Button Six times 6 INSTALLATION & MAINTENANCE ENVIRONMENT Leave some space Maintain at least 10cm between the washer and the wall. ASSEMBLING THE SOUND ABSORBING PANEL Tilt the washer a little and lift up the panel until it clicks, filnaly fix the panel with screw to the base as shown in the figure. Rear-side Place the washer on a sturdy flat surface. If the washer is placed on an uneven or weak surface, noise or vibration occurs. (Allowable is 1°) Adjust the legs for even placement. Never install the washer near water. Do not place the washer in steamy rooms or where the washer is directly exposed to rain. Moisture may destroy the electrical insulation causing an electrical shock hazard. CONNECTING THE DRAIN HOSE After pressing the joint ring(a), insert the drain hose(b) to drain direction. (a) Avoid direct sunlight or heaters. As plastic and electrical components are affected by direct heat, never place the washer near furnaces, boilers, etc. Do not place under direct sunlight. IN CASE OF PUMPDRAINED WASHER q Take out the q cap-hose and connect the outlet-hose. Be sure to join tightly q the drain hose into the drain-outlet on theback of the machine. Install the drain hose in the position of about 70~80cm above the ground. (b) LEVELLING SEE IF THE MACHINE IS PLACED LEVEL BY CHECKING THE POSITION OF THE WASHING TUB. q Open the lid of the machine, pour water into the tub up to the level just below the pulsator, and adjust the legs so that the pulsator is positioned at the center of the water as shown in the figure. q Place the machine more than 10cm away from the wall. cap-hose outlet-hose 70~80cm q Adjust the legs on feet for levelling . Loosen Lock CONNECTING THE WATER SUPPLY HOSE 1. Remove the adaptor from the water supply hose. 4. Connect the water supply hose to the adaptor. Pull down the part (c) of the water supply hose . When the part (c)is released, the hose is automatically connected to the adaptor making a 'click' sound. Connect the other end of the water supply hose to the inlet water valve at the back of the washer. [. . . ] Remove dirts and rotate the filter clockwise until it locks in position. TROUBLESHOOTING Washing machine won't work Is the water tap opened?Is there enough water? Water dose not drain Is the drain hose down?(No pump) Is the drain hose frozen?Is the drain hose clogged? If the water dose not drain in 6 minutes, a buzzer will sound. Water is not supplied Is the water tap opened? [. . . ]