User manual SAMSUNG WA85U7

[. . . ] If the appliance is supplied from a cord extension set or electrical portable outlet device the cord extension set or electrical portable outlet device should be positioned so it is not subject to splashing or ingress of moisture. 2 DESCRIPTION OF PARTS LID Be sure to keep the lid closed during washing and spinning. WATER SUPPLY HOSE(HOT) DETERGENT BOX WATER SUPPLY HOSE (COLD) DRAIN-HOSE (PUMP) FABRIC SOFTENER DISPENSER SPIN BASKET Stainless BLEACH INLET "BOOMERANG" PULSATOR POWER CORD MAGIC FILTER Lint will be collected in the filter during washing. SOUND ABSORPTION PANEL FRONT CONTROL PANEL GROUND LEAD When the water pipe is metal, make sure to cover the end of the ground wire. ADJUSTABLE LEGS Adjust the length of the legs when installing the washer. WATER DRAIN HOSE 3 CONTROL PANEL x POWER BUTTON y START/HOLD BUTTON Press this button once to operate. Press once again to turn the washer off. } WATER LEVEL SELECT BUTTON According to the washload, select the water level ; DELAY START BUTTON Use to pause and restart the operation. To change the washing procedure during operation, press this button to stop, and once again to restart after changing the procedure. Press this button when delay start washing is needed. [. . . ] Press the course select button once. COURSE 2. Press the START/HOLD button. Water level is selected automatically. Washing, rinsing, and spinning follow. If you want to pause, press the START/HOLD button again. You can change the course when paused. 3. Press the START/HOLD button Water level is selected automatically. Washing, rinsing, and spinning follow. If you want to pause, press the START/HOLD button again. You can change the course when paused. START/HOLD START/HOLD 3. Close the lid. washing is it is SPEEDY COURSE Becauselight or less speedy, laundry. good for stained WOOL COURSE Extra low water level is not available. Cold water is selected. 1. Press the power button to "ON". POWER 1. Press the power button to "ON". POWER 2. Press the course select three times. Press the course select button twice. COURSE COURSE 3. Press the START/HOLD button. Washing, rinsing, and spinning follow. If you want to pause, press the START/HOLD button again. You can change the course when paused. START/HOLD 3. Press the START/HOLD button Water level is selected automatically. Washing, rinsing, and spinning follow. If you want to pause, press the START/HOLD button again. You can change the course when paused. 4. Be sure to join tightly the drain hose into the drain-outlet on theback of the machine. Install the drain hose in the position of about 70~80cm above the ground. (b) LEVELLING SEE IF THE MACHINE IS PLACED LEVEL BY CHECKING THE POSITION OF THE WASHING TUB. Open the lid of the machine, pour water into the tub up to the level just below the pulsator, and adjust the legs so that the pulsator is positioned at the center of the water as shown in the figure. Place the machine more than 10cm away from the wall. cap-hose outlet-hose 70~80cm Adjust the legs on feet for levelling . Loosen Lock CONNECTING THE WATER SUPPLY HOSE 1. Remove the adaptor from the water supply hose. 4. Connect the water supply hose to the adaptor. Pull down the part (c) of the water supply hose . When the part (c)is released, the hose is automatically connected to the adaptor making a 'click' sound. 5. Connect the other end of the water supply hose to the inlet water valve at the back of the washer. Screw the hose clockwise all the way in. If the water tap is a screw type, assemble a water supply hose that fits to the tap as shown. 2. First, using a "+" type screw driver, loosen the four screws on the adaptor. Next, take the adaptor and turn part(b) following the arrow for gap about 5mm between them. 3. Connect adaptor to the water tap by tightening the screws firmly. [. . . ] Using too much softener may produce unsatisfactory results. Do not open the lid during the Spin Dry cycle. If added too early, its effectiveness will decrease. Do not leave the softener into the Softener Dispenser for a long time. [. . . ]