User manual SAMSUNG WF338AAW

[. . . ] Avoid using too much detergent in your washer as it can lead to over sudsing and detergent residue being left on the clothes. · The door will not open when the water temperature is over 131 °F. The door will not open when the internal water sensor detects the water level is too high. Do not try to force the door open when locked. [. . . ] If the code reappears, call for service. · Close the door tightly and restart the cycle. If the code reappears, call for service. · Make sure hot and cold water valves are open all the way. · Check the inlet screens on the fill hoses. · Fill the washer drum with 10 of water at the temperature of 140 °F for about 1 hour to defrost the ice. · Unbalanced load prevented your washer from spinning. · Redistribute the load, press the Start/Pause button. · When the weight of the laundry is about · Add more laundry. 1 kg, the center of the weight gets shifted. · To many suds are detected during the washing session. · The unit is put on hold until the suds are reduced. Then, the unit will go back to the operation. When it finishes washing, "End" and "SUdS" code will blink in turn. · Your washer is designed to use High Efficiency (HE) detergents. For best cleaning results only use High Efficiency detergents such as Tide HE, Wisk HE, CHeer HE, or Gain HE. High Efficiency detergent contain suds suppressors that reduce or eliminatesuds. When fewer suds are produced, the wash load tumblesmore efficiently and cleaning is maximized. : DC68-02497A-02_EN SWM-user_QG_3rd. indd 1 2008-01-09 ¿ÀÀü 12:33:15 operating detergent instructions DETERGENT USE · Our washer is designed to use High Efficiency (HE) detergents. [. . . ] · The installation surface must be firm, dry and level. · A carpenter's level should be used on all four corners of your washer. · The unit should not wobble when it is pushed & pressed in all directions. Avoid the damage of legs, do NOT move the washer unless the locking-nuts are fastened to the bottom of the washer. [. . . ]