User manual SAMSUNG WF433BTGJWR

[. . . ] WASHING MACHINE Parts supplied INSTALLATION GUIDE Tools needed Water supply hoses Hose guide Tie strap (option) Tape measure carpenter’s level Pilers Flat screwdrilver 5 French on back  Spanish on back  CONNECTING THE DRAIN HOSE. –¡ CHECK : Solidly constructed floor (Not Carpeting and soft tile surfaces) 2. [. . . ] Confirm whether washer is well seated and does not shake. Your washer must be leveled on all four sides. Use a carpenter’s level on all four corners of your washer to ensure it’s level. Rubber washer Coupling Rubber washer Level the washer by turning the leveling wheel in or out as required by using the supplied wrench. tighten Coupling by hand until it is snug. Then tighten two-thirds of a Run water in a bowl or turn with pliers. Basin to get rid of any debris inside hose. Check whether washer shakes and level again, if necessary. When your washer is leveled, tighten the locking nuts using the wrench or (-) flathead screwdriver. Make sure a Rubber washer is inside each coupling on both ends. Run a test cycle(Rinse+Spin) with small amount of laundry such as 4~5 Towels. (1)  heck for any leakage at the hose connections. [. . . ] Sure both Hot & Cold hoses from faucets are connected to the corresponding Hot / Cold water inlets on the washer. INSTALLATION COMPLETION CHECKLIST □ Washer plugged in, power OK □ No water leakage □ No vibration / noise □ Water hose connected properly □ Washer leveled □ Drain hose connected properly □ Shipping bolts removed DC68-02580C-04  CAUTION: Make sure that the HOT & COLD hoses are switched with each other. [. . . ]