User manual SAMSUNG WT10J7

[. . . ] 3 CONNECTING THE DRAIN HOSE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 CLEANING THE MACHINE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 WASHING PROCEDURE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 TO WASH . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Do not place the washer in steamy rooms or where the washer is directly exposed to rain. Moisture may destroy the electrical insulation and cause an electrical shock hazard. Avoid direct sunlight or heating devices. As plastic and electrical components are affected by direct heat, never place the washer near heaters, boilers, etc. CHANGING THE POSITION OF THE DRAIN HOSE Before attempting to change the position of the drain hose, disconnect the plug from the outlet. Route the drain hose inside the machine. Take out the drain hose from the opposite hole and insert the drain hose into the hose holder. Remark : Should be cleaned Filter at least 1 time a week. CONNECTING THE DRAIN HOSE Insert the drain hose(a) and push it tighly to be connected as arrow direction. HOW TO CLEAN THE FILTER (In case drain pump) (WITHOUT PUMP) Install the drain hose(A) about 70~80cm above the ground for pump model. CLEANING THE MACHINE CLEANING THE LINT FILTER OVERFLOW FILTER CLEANING THE COVER WINDOW SPIN 1. Rotate the cover window spin clockwise and pull out. Insert the cover window spin back and rotate it counterclockwise until locks in positon. Remark : Should be cleaned the cover window spin at least 1 time a month. CLEANING THE WASH TUB Wipe off strains on the cabinet and operation panel with soft cloth. Do not use benzene, thinners, cleanser, or wax, nor scrub the washer with a brush. Painted surfaces or plastic parts will be damaged. 3 DC68-01942C-01_WT10J_IB_ENG. indd4 4 8/9/2006 3:14:23 PM WASHING PROCEDURE TO WASH . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1. Before starting washing, check the following; · Connect the water supply hose and open the water tap. · Connect the power cord to the power supply outlet. · Lay the drain hose(A) down toward a sinkhole. Fill water in the wash tub to the`` L1''lower water level by carefully adjusting the tap water and add the detergent. SOAK · Set the WASH TIMER to the point more than "15" for SOAK function. · If the WASH TIMER is set to the point less than "15", it leads to WASH only. [. . . ] - Be sure remove the cap-hose from the drain hole. See "Before using. . . " on page 1. Is the spin dryer lid closed completely?Are laundry(socks, etc. )falling out of the spin dryer basket and clinging to the axle? [. . . ]