User manual SAMSUNG WT10J7P

[. . . ] 3 CONNECTING THE DRAIN HOSE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 CLEANING THE MACHINE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 WASHING PROCEDURE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 TO WASH . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] As plastic and electrical components are affected by direct heat, never place the washer near heaters, boilers, etc. CHANGING THE POSITION OF THE DRAIN HOSE Before attempting to change the position of the drain hose, disconnect the plug from the outlet. Route the drain hose inside the machine. Take out the drain hose from the opposite hole and insert the drain hose into the hose holder. Remark : Should be cleaned Filter at least 1 time a week. CONNECTING THE DRAIN HOSE Insert the drain hose(a) and push it tighly to be connected as arrow direction. HOW TO CLEAN THE FILTER (In case drain pump) (WITHOUT PUMP) Install the drain hose(A) about 70~80cm above the ground for pump model. CLEANING THE MACHINE CLEANING THE LINT FILTER CLEANING THE COVER WINDOW SPIN Remark : Should be cleaned the cover window spin at least 1 time a month. CLEANING THE WASH TUB Wipe off strains on the cabinet and operation panel with soft cloth. Do not use benzene, thinners, cleanser, or wax, nor scrub the washer with a brush. Painted surfaces or plastic parts will be damaged. 3 WASHING PROCEDURE TO WASH . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1. Before starting washing, check the following; · Connect the water supply hose and open the water tap. · Connect the power cord to the power supply outlet. · Lay the drain hose(A) down toward a sinkhole. Fill water in the wash tub to the`` L1''lower water level by carefully adjusting the tap water and add the detergent. SOAK · Set the WASH TIMER to the point more than "15" for SOAK function. · If the WASH TIMER is set to the point less than "15", it leads to WASH only. (No SOAK) · If Although the machine may stay still maximum 5 minutes, if the WASH TIMER is indicated over 15 minutes position, it is just in the process of soaking and not a breakdown. After washing, set the CYCLE SELECTOR KNOB to `DRAIN' for drain. (WITHOUT PUMP) · Place the drain hose(A) in sink or bath about 70~80cm above the ground. (WITH PUMP) 2. Set the WASH SELECTOR KNOB to the desired mode. Set the CYCLE SELECTOR KNOB to `WASH. RINSE'. (In case no drain pump. ) (`WASH' In case drain pump. ) 9. Soak-Washing 1) Place clothes into the WASH TUB. 3) Put detergent depending on the water volume and detergent package indications. (Without pump) (With pump) 4. [. . . ] Hang up drain hose over the drain hose water and try for drain again. (Scrab will be removed by water drain pressure. ) In case drain pump. - Is the drain hose hung about 70~80 cm above the ground?See "Connecting the drain. . . " on page 3. 2. Clothes will not move freely. Is the laundry overloaded? 5. [. . . ]