User manual SAMSUNG WT11S2

[. . . ] Disconnect the power cord from the power supply when not in use. Ventilation opening must not be obstructed by carpeting when the washing machine is installed on a carpeted floor. If the supply cord of this appliance is damaged, it must only be replaced by a repair shop appointed by the manufacturer, because special purpose tools are required. To avoid overfilling and damages this appliance must be filled with the operator present using a moderate water supply pressure only. PRECAUTIONS WHEN OPERATING Don't use excessively hot water. (50°C or more) Plastic parts may be deformed or damaged. [. . . ] Close the spin dryer lid. OVER FLOW RINSE (A)Type 1. Keep suppling water(adjust water pressure to ensure that the amount of water supplied does not exceed that water drained. ) (B)Type 1. Keep suppling water(adjust water pressure to ensure that the amount of water supplied does not exceed that water drained. ) 2. Be sure to attach the safety cover and close the inner lid. inner lid 4. Set the WASH TIMER 6~8minutes. safty cover 3. As soon as the WASH TIMER shuts off, turn off the water tap. 3. As soon as the WASH TIMER shuts off, turn off the water tap. RINSING (A)Type 1. Set the CYCLE SELECTOR KNOB to WASH RINSE (In case drain pump WASH ) (B)Type 1. Press the DRAIN SELECTOR KNOB to `WASH'. Press the DRAIN SELECTOR KNOB to `DRAIN'. 2. Supply the proper amount of water as not to overflow the top of the washing tub. Supply the proper amount of water as not to overflow the topof the washing tub and put the laundry into the washing tub. ADDITIONAL RINSE (SHOWER RINSE FOR (A)Type for more 1 courseselect onlyeffective rinse (Don't this course for rinse. ) Load the laundry evenly into the spin basket. After rinsing you can select this ) 3. Set the WASH TIMER 2-3 minutes. inner lid safety cover 4 supply, cover the After stopping water laundry with safety cover and close the inner lid. 4. Set the CYCLE SELECTOR KNOB to DRAIN 4. Press the DRAIN SELECTOR KNOB to `DRAIN' . 2 Set the WATER SELECTOR KNOB to SPIN and CYCLE SELECTOR KNOB to `DRAIN'. 5 Close the spin dryer lid. DRY 6 Set the SPINminutes. Repeat this cycle until drain water is clean. Repeat this cycle until water becomes clean. (2-3cycle) water for about 1minute. 3 Supplythe water flow to prevent Adjust overflow from the wash tub. 5 6 INSTALLATION ENVIRONMENT Leave some space Space at last 15cm between the washer and the wall. LAUNDRY GUIDE AMOUNT OF CLOTHES CHANGING THE POSITION OF THE DRAIN HOSE Before attempting to change the position of the drain hose, disconnect the plug from the outlet. Route the drain hose inside the machine. 2. Take out the drain hose from the opposite hole and insert the drain hose into the hose holder. Water Level Shirts(Synthetics) Under Shirts(Cotton) Working clothes(Cotton) Low 22 Pieces 38 Pieces 16 Pieces Middle 29 Pieces 48 Pieces 20 Pieces High 35 Pieces 58 Pieces 25 Pieces Place the washer on a sturdy flat surface. If the washer is placed on an uneven or weak surface, noise or vibration may be occured. [. . . ] CLEANING THE WASHER BODY Wipe off strains on the cabinet and operation panel with soft cloth. Do not use benzene, thinners, cleanser, or wax, nor scrub the washer with a brush. Painted surfaces or plastic parts will be damaged. Clothes will not move freely. Incomplete spinning The spin dryer basket will not run. Are the laundry arranged evenly? Is the spin dryer lid closed completely? [. . . ]