User manual SAMSUNG WT80S0

[. . . ] If nails or pins remain in pockets, they may damage the washer or clothes. Close the water tap a little if the water pressure is too high. q Be sure to cover with the inner cover on laundry before spinning. This prevents laundry from being tossed out and damaged. To avoid water splashes, close the wash tub lid. [. . . ] After washing, set the CYCLE SELECTOR KNOB to `DRAIN' for drain. Load laundry in the wash tub. SPIN DRY 1. Transfer the clothes into the spin basket and arrange the clothes evenly. Be sure to attach the safety cover and close the inner lid. inner lid 4. (or 1-10minutes) safty cover 3 RINSING 1. Set the CYCLE SELECTOR KNOB to `WASH RINSE'. (In case drain pump "WASH") 3. Supply the proper amount of water as not to overflow the top of the washing tub. 4. Set the CYCLE SELECTOR KNOB to `DRAIN' 5. Repeat this cycle until drain water is clean. (2~3 cycles) OVER FLOW RINSE 1. Keep suppling water Adjust water pressure to ensure that the amount of water supplied does not exceed that water drained. 3. As soon as the WASH TIMER shuts off, turn off the water tap. (Without pump) (With pump) 2. Set the WASH TIMER 6~8minutes. 4. Set the CYCLE SELECTOR KNOB to `DRAIN'. ADDITIONAL RINSE for more 1 courseselect onlyeffective rinse (Don't this course for rinse. ) Load the laundry evenly into the spin basket. After rinsing you can select this inner lid safety cover 4 supply, cover the After stopping water laundry with safety cover and close the inner lid. 2 Set the WATER SELECTOR KNOB to SPIN and CYCLE SELECTOR KNOB to `DRAIN'. 5 Close the spin dryer lid. DRY 6 Set the SPINminutes. 3 Supplythe water flow to prevent Adjust overflow from the wash tub. 4 INSTALLATION ENVIRONMENT Leave some space Space at last 15cm between the washer and the wall. HOW TO CLEAN THE FILTER (In case drain pump) 1. Place a rag under the washer filter not to wet the floor. Rotate the filter counterclockwise and pull out the filter. Remove dirts and rotate the filter clockwise until it locks in position. Place the washer on a sturdy flat surface. If the washer is placed on an uneven or weak surface, noise or vibration may be occured. (Allowable is 2°) Never install the washer near water. Do not place the washer in steamy rooms or where the washer is directly exposed to rain. Moisture may destroy the electrical insulation and cause an electrical shock hazard. Avoid direct sunlight or heating devices. As plastic and electrical components are affected by direct heat, never place the washer near heaters, boilers, etc. Do not place under direct sunlight. CONNECTING THE DRAIN HOSE After pressing the joint ring(a), insert the drain hose(b) to drain direction. a b Install the drain hose about 70~80cm above the ground for pump model. CLEANING THE MACHINE A CLEANING THE LINT FILTER If the dregs are filled up in the lint filter after finishing the wash, push down and pull it out as shown in figure. [. . . ] Expand the concave and convex parts, and pull up the spin dryer hatch to remove it. Push in hatch firmly until the catch at the front is engaged securely. screw TROUBLE SHOOTING TROUBLE The washer does not work. CHECK POINT Check that the power cord is connected to a power outlet well. Power stoppage? TROUBLE Incomplete draining CHECK POINT Is the filter clogged with lint? Clothes will not move freely. Incomplete spinning The spin dryer basket will not run. Are the laundry arranged evenly? Is the spin dryer lid closed completely? [. . . ]