User manual SANGEAN ATS-404

[. . . ] If the indicator shown" ", the batteries should be replaced. After removing the batteries you have approximately 3 minutes to replace the batteries after which clock and memory information will be lost. Low battery warnings 1. Replace batteries if display shows " ". 2. Replace batteries if press power button, the radio still not operate. [. . . ] 4. Press the numbered buttons marked 1, 0, 0, 7. Then press ENTER button again, the frequency will now appear in the display . Note: There is no decimal point, therefore before you press the number button, make sure you have selected the required waveband , otherwise the operation may switch to other waveband. 5. Extend the aerial fully and rotate for best FM reception. 6. Adjust the Volume Control for comfortable listening 7. When selecting a stereo FM station and using stereo earphones, make sure the FM model switch is in the stereo position. 5 Manual tuning 1. Press the POWER on/off button to turn on the radio. 2. Select a waveband by pressing BAND button. 3. A single press on the either the TUNING UP " " or DOWN " "buttons will change the frequency up or down. Note: Each press of the up or down button will change the frequency in increment of FM 100kHz MW 9kHz/10KHz SW 5kHz Scan tuning 1. Turn on the radio by pressing the POWER on/off button. 3. Press and hold down either the tuning UP or DOWN buttons for more than half a second to commence scan tuning . The radio will scan all frequencies in the selected band and stop automatically each time it finds an active station. 4. Press and hold down either the tuning UP or DOWN buttons for more than half a second to resume scan tuning. When the waveband end is reached, the radio will beep and continue tuning from the opposite waveband end. 5. Adjust the Volume Control for comfortable listening. Memory tuning You may store up to 45 preset stations in memory. 18 on SW, 18on FM and 9 on MW. To store a station in preset memory proceed as follows. 1. Turn on the radio by pressing the power on /off button. 2. Tune to the desired frequency using one of the previously described tuning methods. 3. Press the button marked 'M' (memory), the memory symbol MEMO together with a suggested preset number will flash in the display for 7seconds. Note :If some of the presets have already been used. the radio will suggest the next available preset location. 4. Press the M button again and your station will be stored in the suggested memory preset. 5. Preset stations may be exchanged easily and at any time. Select the preset that is to be changed by pressing the corresponding numbered button. Press the M button , MEMO and current preset location will flash in the display , whilst the display is flashing, press the new selected preset location using one of the numbered buttons for more than 2 seconds. [. . . ] 1. The HWS alarm is set in the same way as the radio alarm except of pushing " button to select. Push " " button to select HWS alarm. Display will appear "ALARM HWS " for HWS alarm. 2. The HWS alarm can be turned off by pressing the POWER button. " Snooze When the alarm is on, press any button except POWER and light the alarm will be in Snooze function for an interval of 6 minutes before pressing POWER button to turn if off . [. . . ]