User manual SANGEAN DT-200X

[. . . ] To return product for warranty repair: 1. Remove the batteries (if applicable) and carefully pack the unit along with all it's accessories in a suitable well padded corrugated box. Enclose copy of proof of purchase with date and a letter describing your specific problem. Enclose your check or money order payable to Sangean America, Inc. [. . . ] When lock is activated there will be this symbol located on the top of the display. At this time no buttons should function. · To disable the lock function, slide the switch to the down position. 11 12 Belt Clip A removable belt clip is provided on the back of the unit. Removal: It can be removed by gently pushing on the center tab of the clip where indicated, and sliding the clip downward towards the bottom of the radio. Replacement: You can easily connect the belt clip by inserting the top of the clip into the designated receiver slots and gently pushing the clip in an upwards motion towards the top of the radio. 13 Battery Compartment 8 Battery Installation NOTE: A flashing "E" appearing on the LCD display indicates a weak battery and that replacement of batteries is required. · Prepare replacement batteries to ensure a quick and easy change. Failure to change batteries within 1 minute will reset presets and clock settings. · The battery cover is located on the back of the unit. Apply a gentle downward pressure and slide the door to the right side of the unit. · Place 2 `AA' batteries inside the unit oriented to the illustration located just below the battery compartment. Tuning the Radio Seek Tuning · Turn radio on using the On/Off button located on the top of the radio. · Select desired band by pressing the "Band" selector on the front of the unit. · Press and hold the proper tuning button (Up/Down) for approximately ½ second. Radio will seek for next active signal station. · Repeat as many times as desired. 9 Manual Step Tuning · Turn radio on using the On/Off button located on the top of the radio. · Select desired band by pressing the "Band" selector on the front of the unit. · Press the desired tuning button (Up/Down) repeatedly until desired frequency is found. Memory Tuning To tune in stations already programmed into memory. See Setting Memory Section for instructions on how to program stations into radio memory. · Turn radio on using the On/Off button located on the top of the radio. · Press "My Favorites" button located on the right side of the radio. [. . . ] · Press MEMO or CLOCK button once to set the minutes. · The minute indicator should now be blinking. Using the Tuning Control Buttons located just to the right of the display. Adjust UP or DOWN accordingly until desired minutes is displayed. [. . . ]