User manual SANGEAN PR-D5

[. . . ] Power sources: The radio should be operated only from the type of power source indicated on the marking label. If you are not sure of the type of power supply to your home, consult your radio dealer or power company. Power cords: The power cord should be positioned so it is not walked on, pinched, or items placed on top of it. Pay particular attention to cords at plugs, convenience receptacles, and the point where they exit from the unit. [. . . ] Object and Liquid Entry-Never push objects of any kind into this radio through opening as they may touch dangerous voltage points or short-out parts that could result in a fire or electric GB shock. Never spill liquid of any kind of product. Power button AUX In signal Band and Tuning step selection Alarm set CT Display LCD display Tuning/SET/AUTO SEEK knob Volume Control Preset buttons FM Stereo/Mono switch AUX IN socket Earphone socket DC input socket Antenna Battery compartment Clock can be set either the radio is power on or off. Press the SET knob (on the side of the radio) for more than 2 seconds, display will flash time set symbol and also the hour digits, followed by a beep. There are 3 bands which are FM, AM and AUX-IN. Rotate the Volume knob (on the side of the radio) to get required sound level. There are 5 memory presets for each waveband ­ STATION PRESETS 1 to 5. Stations stored in preset memories can be overwritten by following above procedures. This function only applies when FM station which is listening provides the RDS service. When FM station provides RDS service, shows on the display and the display shows the program type and then shows the radio text if radio text is provided. Press and hold CT button for more than 2 seconds until it beeps, then the radio clock time will be automatically corrected. When it shows "No CT" means there is no service. Turn on the radio, and press the STEP/BAND button until "AUX" is displayed. To activate the alarm, press and hold the ALARM button for more than 2 seconds and it will beep and the display will show "ALARM". To deactivate the alarm, press and hold the ALARM button for more than 2 seconds and it will beep and the "ALARM" will disappear from the display. When the radio alarm is selected, the radio will turn on and play the last played radio station at the chosen alarm time. (If it is under AUX band, or the battery is low, then the alarm will sound by buzzer). The radio alarm will continue for one hour unless turned off by pressing the Power button. The alarm time may be set after the clock time is set. The alarm can be set either radio is on or off. [. . . ] Then rotate the TUNING knob to switch 24/12 hour system. Press the STEP/BAND button and then rotate the TUNING knob to switch MW (AM) step which is MW 9KHz or MW 10 KHz. Note: After the tuning step is switched, AM station presets are erased. When FM signal is weak, some hiss may be audible. [. . . ]