User manual SANGEAN RCR-8WF

[. . . ] User Manual RCR-8 Contents Important safety instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-4 Controls . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-8 Before you can use this product . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 Connecting your radio to your network . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Once the radio has finished scanning, it will display "By Album", "By Artist", etc. Use the Tuning+/- buttons to scroll through the scanned media files, which will now be organized `By Album', `By Artist' and `Playlists' ­ if available. And refer to "Operation after you set up for Window Shares , UPnP or USB/SD card" below for the operation. GB 22 UPnP server Set up a Windows PC to allow the radio to access your audio files via a UPnP server 1. If your PC is running Microsoft Windows XP or Windows Vista then you can use Microsoft's Windows Media Player 11 (WMP 11) to act as your UPnP (Universal Plug and Play) media server. If not already installed on your PC, Windows Media Player 11 may be downloaded from Microsoft's website and installed by following the instructions detailed in its installation wizard, or by using Microsoft's Windows Update facility. Once installed, WMP 11 can create a library from all the media files available to it on your PC. To add new media files to the library, select `File > Add to Library. . . > Advanced Options', click `Add' and choose the files you wish to add and click `OK'. You will now need to connect your Internet radio to Windows Media Player 11 and configure it to allow the radio to access your media library. In order to this, you will need to follow these next steps. Use the Tuning+/- and the Select buttons to enter the menu direction "Media Player> UPNP Servers". Note, this may take a few seconds for the radio to complete its scan and before the scan has completed, the radio will display `No PC Found'. The radio will continue to display "No PC Found" if no UPnP servers are found. After scanning, select your UPnP server (press the Tuning+/- and the Select button if more than one UPnP server is found), and then press the Select control. Your radio will normally display `Access Denied' at this stage. Your PC may now prompt you that a device has attempted to connect to your UPnP server. Whether you are prompted or not, in order to allow the radio to have access to the media files, you will need to click the `Library' tab in WMP 11 and select the `Media Sharing. . . ' item to open the `Media Sharing' window. From the `Media Sharing' window, the radio will be listed as an unknown device. Click on the unknown device shown to select it, then click the `Allow' button and then click `OK'. Note: If you are using Microsoft Windows' firewall software, this should be correctly configured by WMP 11. If you are using third party firewall software you may need to manually configure it to allow your radio and WMP 11 to communicate. Select the named server again using the Tuning+/- and the Select buttons. [. . . ] The display will show "Are you sure?" Press the Tuning+/- buttons to select "YES". Now the radio is factory reset. Upgrade firmware From time to time, new software features for your radio may be developed. For example, a new audio decoder may be added to allow an alternative audio format to be supported. You radio has therefore been designed to allow its internal software to be upgraded using your Internet connection. [. . . ]