User manual SANGEAN U3

[. . . ] Only use attachments/accessories specified by the manufacturer. Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over. Unplug this apparatus during lightning storms or when unused for long periods of time. [. . . ] Press the Scan button again to pick up the found station. GB 8 Note: The radio will continue to search next available stations if you do not press Scan button again when it finds a radio station. Rotate the Volume Control and Tone Control to get required sound level. To turn off the radio, press the Power button. Press the Power button to turn on the radio. Select the required waveband by pressing the Band button. A single press on either rotate the Tuning Control knob will change the frequency in the following increments: FM: 50 or 100 kHz MW (AM): 9 or 10 kHz 4. Rotate the Volume Control and Tone Control to get required sound level. To turn off the radio, press the Power button. Display will show OFF. 9 Storing stations in preset memories There are 5 memory presets for each waveband. Press the Power button to turn on the radio. Tune to required station using one of the methods previously described. Press and hold down the required preset until the radio beeps. The preset number will appear in the display and the station will be stored under chosen preset button. Repeat this procedure for the remaining presets. Stations stored in preset memories can be overwritten by following above procedures. Recalling stations from preset memories 1. Press the Power button to turn on the radio. Momentarily press the required Preset button, the preset number and station frequency will appear in the display. GB Setting the radio alarm When the radio alarm is selected, the radio will turn on and play the chosen radio station at the chosen alarm time. The radio alarm will continue for one hour unless turned off by pressing the Power button. Press the Power button whilst the alarm is activated will cancel the alarm for 24 hours. 10 Note: Radio alarm can be activated only until both radio alarm time and radio alarmed station are set. Radio alarm will be automatically switched to Buzzer alarm when the radio is in low battery status or the selected radio alarm station signal is too weak. The radio alarm can be set either radio is on or off. Press and release radio alarm button , the radio alarm symbol will flash. [. . . ] After FM tuning step is reset, pressing Step/Band button again, GB display will show MW and flash 9 kHz. By rotate Tuning Control knob, you may adjust to 10 kHz per tuning step. Complete the setting by pressing Step/Band button. Aux and Headphones sockets 1. The Aux socket (3. 5 mm) on the right side of your radio is for use with a tape recorder/mini disc or any other equipment that can provide a line level signal. [. . . ]