User manual SANICOM FF03-P95

[. . . ] For any additional information, please contact our customer service department. 2- Isolation valves should be fitted to the inlet pipework and discharge pipework to isolate the unit in case of the need for service. 3- This evacuation pipe must be designed so as to prevent back-flow from the sewers. [. . . ] Ensure that the unit is easily accessible for possible maintenance. The tank is equipped with a sensor tube which controls the automatic activation of the motor when waste enters the unit. As soon as the waste enters the tank, the pump starts. 2 LIST OF PARTS SUPPLIED 3 DIMENSIONS 4 SANICOM® TECHNICAL DATA AND APPLICATION Sinks , washing machine , dishwasher or shower* or bath* Type FF03-P95 Maximum vertical pumping height 8m Voltage 220 ­ 240 V Frequency 50 Hz Maximum power consumption 750 W Maximum current consumption 3. 3 A Electrical class I Protection index IP44 Max temp with intermittent functioning 90° Net weight 10 kg * In the case of bath or shower tray, make sure the waste traps are raised 15 cm above floor level. All applications other than those described in this notice are prohibited. Do not exceed an incoming flow rate greater than 80% of the flow rate stated on the design curve 5 in any of the apparatus. The unit requires a 220/240 V single phase AC 50 Hz supply (UK specification). Do not connect the unit to a conventional plug and socket. the unit should be connected to a fully earthed electrical supply (class 1). It must be wired into an unswitched fused fixed wiring connector protected by a 10 amp fuse and a residual current detector (30 mA). This connection must be used exclusively for supplying the SANICOM unit. The wires in the mains lead are coloured in accordance with the following code: Brown Live Blue Neutral Green/Yellow Earth WARNING: Ensure the electricity is turned OFF at the main switch board before wiring to connector. All work on cable, pressure chamber and motor should only be carried out by a qualified SANIFLO servicing agent, as special tools are required. CAUTION: When the apparatus is connected up for the first time, it will work for 5 seconds even if there is no water in the basin. 7a FITTING 1- Warning: The space in which SANICOM® is installed must be large enough to leave at least 600mm around the unit for easy maintenance. This space must be well lit, ventilated, and must never be immersed in water and must be protected from frost. Lifting station for waste products not containing faecal matter. [. . . ] 1 USE 1 SANICOM® is designed for disposing of wastewater originating from sinks, clothes washing machines, dishwashers, showers or baths and basins. Locate the motor into the adaptor plate, ensure it is firmly home and turn it clockwise until the reference marks line up. Screw in the six screws into the adaptor plate. [. . . ]