User manual SANUS COMPONENT FURNITURE ARMOIRE-CFAR47CB

[. . . ] Thread a Floor Spike into each of the four holes in the bottom of the Frames. Turn the Component Foundation back over and place it where you intend to use it. Adjust the Floor Spikes so that the Component Foundation is level and does not rock. [. . . ] Set the Top Shelf in place making sure that the weight of the shelf is on the Plastic Spacers. (See Photo 9) *NOTE: The ends of the Floor Spikes and the Shelf Studs are very sharp and may scratch floors or furniture. All small sharp objects can be hazardous to children. The decision to use spikes is yours; Sanus Systems will not be liable for damage or injury. Page 4 SANUS SYSTEMS www. sanus. com PHOTO 6 INSTRUCTION MANUAL FOR COMPONENT FURNITURE MODEL CF3 PHOTO 7 Shelf Shelf Stud Isolation Disc PHOTO 8 PHOTO 9 3785 Lexington Ave St. Paul MN 800-359-5520 b a c PHOTO 1 on its back on a flat surface to ensure that is level. Tighten the bolts making sure that the frames stay level and do not twist. (See Photo 2) 3] Put both Mid Shelf Rails in front of you with four 1/2" Bolts. Attach the Mid Shelf Rails to the Frames. Six Short Shelf Studs support the middle shelf. Thread a Thin Nut over each Short Shelf Stud. Thread a Short Shelf Stud into the hole of each Mid Shelf Rail. After the shelf is leveled in step 9, the nut may be tightened to lock the Shelf Stud. (See Photo 3) 4] Two Trim Pieces are included. Attach the Trim Pieces to the Angle Braces with three 1. 5" bolts and Plastic Spacers. The Plastic Spacers should be positioned between the Angle Brace and the Trim Piece. (See Photo 4) The bottom of the lower Trim Piece should be 1/4" higher than the bottom of the Frame­ this is accomplished by positioning the bolt at the lowest point in the slot on the lower Angle Brace. The top of the upper Trim Piece should be flush with the top of the frame­ this is accomplished by positioning the bolt at the highest point in the slot on the upper Angle Brace. 5] The Long Shelf Studs support the top and bottom shelves. Thread the Long Shelf Studs into the holes in the lower and upper Angle Braces. [. . . ] Attach with three 1/2 Bolts ­ finger tight. Attach the other Frame to the other end of the Angle Brace. In the same manner, attach the remaining three Angle Braces to the frames. [. . . ]