User manual SANUS COMPONENT FURNITURE AUDIO TOWER-CFA56CB

[. . . ] If you wish to install the Carpet Spikes (a), thread each Carpet Spike into the foot as seen in Diagram 1. You can adjust the height of the Carpet Spikes with the Nut shown in the Detailed View of Diagram 1. Warning: The ends of the carpet spikes are sharp and may scratch floors or furniture. [. . . ] Make sure the arrow on each Cam is facing the hole in the outside of the Back Rail and add two Cam Pins to each end of the Back Rail as shown in the Detailed View of Diagram 4. Insert the Cam Pins until there is a small space between the head of the pin and the Back Rail. Attach the Back Rail by sliding the cam pins down the groove on the Side Panel pillar as shown in the Top View of Diagram 4. Once the Back Rail is resting on the Foot (o), tighten the cams labeled in Diagram 4 to hold it in place. Make sure the bottom Back Rail is oriented so the threaded holes near the ends are on the top, and the Cams face inside the cabinet, as seen in Diagram 4. Make sure the top Back Rail is oriented so the threaded holes near the ends are on the bottom, and the Cams face inside the cabinet, as seen in Diagram 4 Diagram 4 Detailed View Top View (Back Left Corner) s cam b t s b Step 5: Add the Back Panel Insert a Back Panel Bolt (d) through the Back Panel (u), a Spacer (e) and thread it into the Back Rail (s) as seen in the Detailed View of Diagram 5. Repeat the process until all 4 Back Panel Bolts are attached to the Back Rails. Proceed to tighten the Back Panel Bolts. Diagram 5 Detailed View s e d u Step 6: Add Isolation Pads to Isolation Shelf Add an Isolation Pad (l) to each hole in the Isolation Shelf (y) by peeling off the adhesive cover from the soft side of the Isolation Pad as shown in the Detailed View of Diagram 6. Make sure the soft side of the Isolation Pad is facing toward the shelf when inserting it into the Isolation Shelf. Detailed View Diagram 6 y l Step 7: Add Shelves Add 4 Shelf Pins (g) for the Isolation Shelf (y) at the desired height as shown in Detailed View A of Diagram 7. Next, align the holes on the bottom side of the Isolation Shelf with the Shelf pins, and proceed to place the shelf on the Shelf Pins. You can level the Isolation Shelves by adjusting the Bolt in the Shelf Pin. To add the Glass Shelf (x), insert 4 Shelf Pins (g) at the desired height into the Side Panels as shown in the Detailed View B of Diagram 7. Proceed to place the Glass Shelf on the Shelf Pins. Thread a Bottom Shelf Pin (f) into the Side Panel (t) as shown in Detailed View C of Diagram 7. Repeat process until all four Bottom Shelf Pins have been inserted into the Side Panel. Proceed to press fit the Bottom Shelf (z) so it is locked into the Bottom Shelf Pins. [. . . ] Proceed to tighten the Hinge Plate Screws with a phillips screw driver until tight. To attach each Hinge (q) to its Hinge Plate, the bolt along the back center of the Hinge Plate must be loose during installation. The slot on the end of the Hinge will fit around the bolt on the Hinge Plate. [. . . ]