User manual SANUS COMPONENT FURNITURE VIDEO LOWBOY-CFV47CB

[. . . ] You can adjust the height of the Carpet Spikes with the Nut shown in the Detailed View of Diagram 1. Warning: The ends of the carpet spikes are very sharp and may scratch floors or furniture. All sharp objects can be hazardous to children. For this reason we provide the carpet spikes as an option. [. . . ] Attach the Back Rail by sliding the cam pins down the groove on the Side Panel pillar as shown in the Top View of Diagram 4. Make sure the bottom Back Rail is oriented so the threaded holes near the ends are on the top, and the Cams face inside the cabinet, as seen in Diagram 4. Make sure the top Back Rail is oriented so the threaded holes near the ends are on the bottom, and the Cams face inside the cabinet, as seen in Diagram 4. Once the Back Rail is resting on the Foot (p), tighten the cams labeled in Diagram 4 to hold it in place. Diagram 4 Detailed View Top View (back left corner) b cam b y x x Step 5: Add the Back Panel Insert a Back Panel Bolt (d) through the Back Panel (z), a Spacer (c) and thread it into the Back Rail (x) as seen in the Detailed View of Diagram 5. Repeat the process until all 8 Back Panel Bolts are attached to the Back Rails. Proceed to tighten the Back Panel Bolts. Note: Position of Top Back Rail may need to be adjusted for the Back Panel to fit properly. Diagram 5 Detailed View x c d z Step 6: Add Bottom Shelf Bracket Thread a Phillips Pan Head Bolt (e) though each hole in the Bottom Shelf Bracket (p), and into the Back Rail (x) as seen in the Detailed View of Diagram 6. Do not fully tighten the Phillips Pan Head Bolts during this step. Diagram 6 Detailed View x e p Step 7: Add Bottom Shelf Thread a Bottom Shelf Pin (h) into the Side Panel (y) as shown in the Detailed View of Diagram 7. Repeat process until all four Bottom Shelf Pins have been inserted into the Side Panel. Proceed to press fit the Bottom Shelf (u) so it is locked into the Bottom Shelf Pins. Detailed View Diagram 7 y h u Step 8: Attach Brackets to Bottom Shelf Gently rotate the cabinet so it is resting on its back. Thread a Wood Screw (i) through each hole in the Bottom Shelf Retainer (o) and into the Bottom Shelf (u) as seen in Detailed View A of Diagram 8. Next, Thread a Wood Screw through each hole in the Bottom Shelf Bracket (p) and into the Bottom Shelf as seen in Detailed View B of Diagram 8. Proceed to tighten all four Wood Screws with a phillips screw driver. Once complete, tighten the Phillips Pan Head Bolts from Step 6 until they are tight. Detailed View A Diagram 8 u i o Detailed View B u i p Step 9: Add Glass Shelf To add the Glass Shelf (v), insert 4 Shelf Pins (g) at the desired height into the Side Panels (y) as shown in the Detailed View of Diagram 9. Proceed to place the Glass Shelf on the Shelf Pins. Detailed View Diagram 9 v g y Step 10: Fit Top to assembly Insert a Dowel (f) into each corner hole in the bottom side of the Top (t). [. . . ] Repeat the process until both Hinge Plates are attached. Proceed to tighten the Hinge Plate Screws with a phillips screw driver until tight. To attach each Hinge (q) to its Hinge Plate, the bolt along the back center of the Hinge Plate must be loose during installation. The slot on the end of the Hinge will fit around the bolt on the Hinge Plate. [. . . ]