User manual SANUS FLAT PANEL FOUNDATIONS-FF1

[. . . ] Step 6: Attach Speaker to Pillar Attach the speaker wire to the speaker and place it through the wire management hole that is labeled in the Detailed View of Diagram 6. Proceed to attach the speaker by placing the appropriate Bolt (g, h, i) through the corresponding hole in the Bracket (j), then through the slot in the Pillar (n) and finally threading it into the speaker. If there is a second attachment point on the speaker, repeat the process. [. . . ] If you have any questions regarding this product, contact Sanus at 800. 359. 5520 or visit www. sanus. com. Our customer service representatives can quickly assist you with missing or damaged parts. Replacement parts for Sanus products purchased through authorized dealers can be shipped directly to you. Please call Sanus Systems before returning products to the point of purchase. Required Tools: Phillips Screw Driver. j g, i n h Step 1: Check carefully to make sure all parts and hardware are accounted for. Diagram 1: Parts and Hardware (Hardware is shown as actual size) *not shown at same scale wire management hole (6) Foot Top - a Step 7: Add Wire Cover Make sure the speaker wire has been run down the Pillar (n). Proceed to snap the plastic Wire Covers (o) into the Grooves in the Pillar. See the Top View Diagram 7 for assistance. The speaker wire should run out the space below the Wire Covers just above the glass Base. Diagram 7 Top View (6) Foot Stud - b (6) Foot Bottom - c (20) Nylon Washer - d (6) Carpet Spike - e (8) M8 x 25 Bolt - f wire cover foot (4) 1/4-20 x 1. 25 Bolt - g (4) M4 x 50 mm Bolt - h (4) 1/4 - 20 x . 875 Bolt - i pillar (4) Bracket - j (2) Base - k* (2) Pad - l* (2) Top Cap - m* Sanus Systems 2221 Hwy 36 West, Saint Paul, MN 55113 2. 14. 05 Customer Service: 800. 359. 5520. See complementary Sanus products at www. sanus. com (2) Pillar - n* (2) Wire Cover - o* Sanus Systems 2221 Hwy 36 West, Saint Paul, MN 55113 2. 14. 05 Customer Service: 800. 359. 5520. See complementary Sanus products at www. sanus. com Step 2: Assemble Feet to Base Assemble the Feet to the Base by placing a Foot Stud (b) through the Base (k), a Nylon Washer (d) and into a Foot Bottom (c). Then, slide another Nylon Washer over the Foot Stud and thread a Foot Top (a) onto the Foot Stud until the assembly is tight. Repeat this step for the other two Feet. Step 4: Add Top Cap to Pillar Add the Top Cap (m) by simply press fitting it to the top of the Pillar (n), as shown in the Detailed View of Diagram 4. [. . . ] For this reason the use of the Carpet Spikes is an option. The decision to use steel spiked feet is yours; Sanus Systems is not liable for damage or injury. n l Diagram 5 Detailed View k d f c e [. . . ]