User manual SANUS JAVA FURNITURE-JFA36

[. . . ] Our customer service representatives can quickly assist you with installation questions and missing or damaged parts. Replacement parts for products purchased through authorized dealers will be shipped directly to you. Improper installation may cause damage or serious injury. [. . . ] Tighten each Cam Pin with a Phillips screw driver. Make sure the arrow on each Cam is pointed toward the closest hole. Press fit each rail together until a solid rectangle is formed. Tighten each Cam that corresponds with a Cam Pin in a clockwise motion to secure the Rails together. Step 4: Add Base Assembly to Bottom Align the assembled base frame so the holes line up with the Dowels (c) and Cam Pins (b) on the Bottom (p). Step 6: Add Door Latch Attach the Door Latch (m) to the Top (o) with the four Latch Screws (n). Tighten each Latch Screw with a Phillips screw driver. Insert a Cam Pin (b) into each threaded hole and insert a Dowel (c) into each adjacent hole in the Top (o). Tighten each Cam Pin with a Phillips screw driver. Make sure the arrow on each Cam points toward the appropriate Cam Pin in the Top (o). Insert the Door (u) into the base so the pivot side is opposite from the Door Latch (m). Fit the Top onto the Side Panels so the Cam Pins correspond with the Cams and the Door is secured in the top. Detailed View View from Front View from Back Step 9: Add Legs To add the Legs (v) first slide the Rubber Spacer (e) so it fits into the Aluminum Spacer (f). Take a M6 Bolt (d) and insert it through the Side Panel (s, t), the Spacer Assembly and finally thread it into the Leg. [. . . ] Tighten each Back Panel Screw with a Phillips screw driver. Repeat process for the other Back Panel. Note: Sanus recommends placing components and completing all necessary wire and cable hook-ups before attaching the Back Panels. [. . . ]