User manual SANUS JAVA FURNITURE-JFV65

[. . . ] Proceed to tighten each Cam Pin with a Phillips screw driver. Next, orient the Barrel Nut (d) so the hole in its side faces the hole in the back of the Top. Proceed to insert each Barrel Nut into the hole as shown in the Detailed View of Diagram 1. Then thread each Barrel Nut Bolt (e) into the hole on the back of the Top, as pictured in the Detailed View of Diagram 1. [. . . ] Next, orient the Barrel Nut (d) so the hole in its side faces the hole in the back of the Top. Proceed to insert the Barrel Nut into the hole as shown in the Detail View of Diagram 5. Then thread the Barrel Nut Bolt (e) into the hole on the back of the Bottom, as pictured in Diagram 5. Tighten each Barrel Nut Bolt so that they protrude a 1/4" From the Top. Detailed View d e Diagram 5 channel p track Step 6: Add Bottom Flip the Bottom (p) so the track and channel are facing down. Align the bottom piece so it is resting on the Panels (q, r, s, t) with the 4 large holes toward the back as shown in Diagram 6. Insert a Base Bolt (l) through the Bottom and into the appropriate hole in the Panel. See the Detailed View of Diagram 6 for assistance. Detailed View Diagram 6 l p Step 7: Prepare Bottom Insert 6 Cam Pins (b) and 6 Dowels (c) into the Bottom (p) as shown in the Detailed View of Diagram 7. Tighten all Cam Pins with a Phillips screw driver until they are tight. Detailed View Diagram 7 c b p Step 8: Assemble Base Insert 4 Cam Pins (b), 4 Dowels (c), and 10 Cams (a) as shown in Diagram 8. Tighten Cam Pins with a Phillips screw driver. Then, attach the Front Base Rails (w) to the Side Base Rails (x). Proceed to tighten the 4 Cams on the Side Rails. Once assembled, the rails should form a solid rectangle. c x Diagram 8 w a b Note: Cams should be tightened in a clockwise motion Step 9: Add Base Assembly to Bottom Flip and align the assembled base frame so the holes in the assembled base frame line up with the Dowels (c) and Cam Pins (b) on the Bottom (p). Proceed to tighten all 6 of the Cams (a) on the Front Base Rails (w) that correspond with the Cam Pins on the Bottom so that the assembled base frame is secured to the Bottom. Diagram 9 a p b w c Note: Cams should be tightened in a clockwise motion Step 10: Add Legs To add the Legs (y) first slide the Rubber Spacer (g) so it fits into the Aluminum Spacer (h). Then take a M6 Bolt (f) and insert it through the Outside Panel (s, t), the Spacer Assembly and finally thread it into the Leg. See the Detailed View of Diagram 10 for assistance. Repeat this process for the remaining holes on the left and right leg. [. . . ] Then, insert the last Back Panel into the middle slot. Note: The last Back Panel that is inserted should go in the middle. Make sure the left and right Back Panel slide into the channel in the Outside Panels. Diagram 13 aa Step 14: Add Doors Add 2 Door Protectors (k) to each side of the door as shown in the detailed View of Diagram 14. [. . . ]