User manual SANUS JAVA FURNITURE BACKDROP-JFBD1

[. . . ] Improper installation may cause property damage or personal injury. If you do not understand these directions or have any doubts about the safety of the installation, call a qualified contractor or contact Sanus at 800. 359. 5520 or www. sanus. com. Sanus Systems can not be liable for damage or injury caused by incorrect mounting, incorrect assembly, or incorrect use. [. . . ] Figure 1 Bottom Backboard (B) Backboard Joining Plate (C) Lock washer (F) Screw (e) Step 2: Attach Bottom Backboard to JFV65 Lowboy CAUTIoN The Bottom Backboard (B) is heavy. To avoid injury or product damage, two people must lift the Backboard. Position the Bottom Backboard (B) on the JFV65 as shown in Figure 2. The pre-drilled holes on the long edge of the Backboard should face up. Pre-drilled holes on this edge Backboard Joining Plate (C) NoTe If these threaded inserts are not present on your furniture, contact Sanus Customer Service for a JFRU Update Kit. NoTe Do not fully tighten the ¼-20 x 0. 5 Screws (E) until assembly is complete. Attach the Bottom Backboard (B) and Backboard Joining Plates (C) to your JFV65 and the Mounting Rails with eight ¼-20 x 0. 5 Screws (e) and eight ¼ Lock Washers (F). Figure 3 Lock washer (F) Bottom Backboard (B) Screw (e) Backboard Joining Plate (C) Lock washer (F) Screw (e) Step 3: Attach Top Backboard to JFV65 CAUTIoN The Top Backboard (A) is heavy. To avoid injury or product damage, two people must lift the Backboard. Position the Top Backboard (A) on the Bottom Backboard (B). Make sure the dowels on the Top Backboard fit into the holes on the Bottom Backboard. Push the Backboards together so there is no gap between them. Use eight ¼-20 x 0. 5 Screws (e) and eight ¼ Lock Washers (F) to fasten the Top Backboard to the Backboard Joining Plates (C), and the Mounting Rails as shown in Figure 4. Make sure all twenty-four of the ¼-20 x 0. 5 Screws are tight. Figure 4 Lock washer (F) Lock washer (F) Screw (e) Screw (e) Top Backboard (A) Backboard Joining Plate (C) Bottom Backboard (B) Step 4: Attach wall Plate Provided with VMPL50, VMPL250, VMPL, VMPL2, or VMPL3 Decide where you would like the Wall Plate and mark the position of the two bottom holes through the slots in the Mounting Rails. Use Table 1 below to correctly locate the position of the two upper slots in the Mounting Rails. Table 1: Vertical() Distance Between Wall Plate Slots VMPL50 4. 5 in (114. 3 mm) VMPL250 4. 5 in (114. 3 mm) VMPL 6. 5 in (165. 1 mm) NoTeS Place a piece of tape over the areas where the drill bit will come through the Backboards (A and B). This helps to prevent chipping of the wood surface. [. . . ] However, CSAV makes no claim that the information contained herein covers all details, conditions, or variations. Nor does it provide for every possible contingency in connection with the installation or use of this product. The information contained in this document is subject to change without notice or obligation of any kind. [. . . ]