User manual SANUS NATURAL FURNITURE AV STANDS-NF203 NF213 NFV49

[. . . ] Assembly Instructions for Natural Furniture, Models: NF203, NF213, NFV49 Thank you for choosing the Natural Furniture line from Sanus Systems. If you have any questions regarding this or any other Sanus Systems product, please contact us at 800. 359. 5520 or visit us at www. sanus. com. [. . . ] See complementary Sanus products at www. sanus. com Allen Bolt - I Qty. 1 Step 1: Attach the Cross Tubes to the Front Frame Position the Front Frame (A) as shown in Diagram 1; then, thread each Decorative Face Bolt (K) through the Front Frame, a Three Hole Plate (C) and into a Steel Cross Tube (B). Repeat this process until all twelve Steel Cross Tubes (B) are fastened to the Front Frame (A) as shown in Diagram 1. Firmly hand tighten each Steel Cross Tube (B). Diagram 1 A C B K Step 2: Attach Rear Supports NOTE: The Rear Supports (E) must be positioned with set of three holes closest to the edge toward the top and the horizontal slots facing the Front Frame (A). Thread an Allen Bolt (I) through a Washer (J), the middle hole in a Rear Support (E), the middle hole in a Three Hole Plate (C), and into the middle Steel Cross Tube (B), as shown in Diagram 2. Repeat this procedure until all four middle Allen Bolts, accompanying Washers, and Rear Supports are attached to the middle Steel Cross Tubes. Thread an Allen Bolt (I) through each hole of the Wire Straps (H), the Rear Supports (E), each outer hole of the Three Hole Plates (C), and into the outer Steel Cross Tubes (B) as shown in Diagram 2. Using the Allen Key (M), tighten all twelve Allen Bolts (I). Diagram 2 Three holes near edge toward top. C E J H I B I Horizontal Slot Step 3: Install Glass Shelves NOTE: Make sure the round edges of the Glass Shelves are to the sides and the flat edge fits into the horizontal slot in the Rear Support. Install the Glass Shelves (D) so the back of each Glass Shelf fits into the horizontal slot in the Rear Support (E), and the front of the Glass Shelf sits down into the groove in the Front Frame (A) as shown in Diagram 3. Diagram 3 A E D Horizontal Slot Step 4: Add Top Glass Shelf Place four Glass Protectors (L) evenly along the top of the Front Frame (A); then, add two Glass protectors to the top of each Rear Support (E). [. . . ] Diagram 5 Top View Plastic Wire Cover (F) Grooves in Rear Support (E) E H F Sanus Systems 2221 Hwy 36 West, Saint Paul, MN 55113 04. 06. 06 (100043) Customer Service: 800. 359. 5520. See complementary Sanus products at www. sanus. com [. . . ]