User manual SANUS NATURAL FURNITURE MEDIA TOWER-NFCD

[. . . ] Assembly Instructions for Model: NFCD Thank you for choosing a Sanus Systems Natural Media Tower. The Model NFCD is designed to keep your collection clean and organized by storing up to 430 CDs or 230 DVDs, all in one convenient location. If you do not understand these directions, please contact Sanus at 800. 359. 5520 or www. sanus. com. [. . . ] See complementary Sanus products at www. sanus. com Supplied Hardware: (Full Size) Cam - H Qty. 56 Step 1 - Attach Feet to NFCD Base Insert a Machine Screw (K) into each Foot (C); then using the regular screwdriver, attach the Feet to the NFCD Base (B). Diagram 1 B C K K K C K C C Step 2 - Insert Cam Pins into Side Panels There are two holes that are centered on each side of the Side Panels (E), and 12" [304. 3 mm] from each end. Using the phillips screwdriver, screw Cam Pins (I) into the two holes of each Side Panel taking care not to over tighten the Cam Pins. Diagram 2 E E I Step 3 - Insert Cam into Center Support. Place a Cam (H) into each of the four holes in the Center Support (D) NOTE: Each Cam has an arrow on it. Using a phillips screwdriver align each Cam so the arrow is pointing toward the small hole on the edge of the Center Support (See Detail - A). Diagram 3 Cam - H Cam Hole Cam - H Small Hole Detail - A D Small Hole Step 4 - Secure Side Panels to Center Support. The Cam Pins (I) installed in each Side Panel (E) line up with the small holes in the edge of the Center Support (F). The top of each Side Panel is smooth and the bottom has a notch routed in the inside edge. Attach a Side Panel to each side of the Center Support and using a phillips screwdriver, rotate each Cam (H) clockwise until tight (See Detail - B). Diagram 4 Top Smooth I H E F E Detail -B Bottom Notched Step 5 - Attaching NFCD Top Panel Stand the unit up so that the notched bottom of each Side Panel is facing down and the smooth top edge is facing up. Tap a Plastic Dowel Pin (J) into the holes in the top edge of each Side Panel (E); then, align the holes of the NFCD Top (A) with the Dowel Pins and the slot across the NFCD Top with the Center Support (D). Firmly press the NFCD Top onto the Dowel Pins and Side Panels, until it is firmly seated. [. . . ] Diagram 7 M F Step 8 - Attach Name Plate Attach the Sanus Name Plate (G) In the desired location. Diagram 8 G Sanus Systems 2221 Hwy 36 West, Saint Paul, MN 55113 02. 28. 06 (100028) Customer Service: 800. 359. 5520. See complementary Sanus products at www. sanus. com [. . . ]