User manual SANUS NATURAL FURNITURE MEDIA TOWER-NFCDII

[. . . ] Check carefully to make sure that there are no missing or defective parts. Our customer service representatives can quickly assist you with assembly questions, and missing or damaged parts. Replacement parts for products purchased through authorized dealers will be shipped directly to you. [. . . ] If necessary, the rubber mallet may be used to lightly tap them into place. Diagram 1 D O Step 2 - Secure Steel Tube to Front Leg Lay the Front Leg (D) face down on a soft surface with the threads of the Decorative Face Bolts (O) facing up; then, place a Washer (Q) over the middle Decorative Face Bolt, and thread the Steel Tube (G) onto it. Diagram 2 Q D G Step 3 - Secure Front Leg to NFCDII Base Attach the Front Leg (D) to the NFCDII Base (B) by inserting the two outer Decorative Face Bolts (O) through the two holes of the NCFDII Base and securing with two Nuts (P). Use the adjustable wrench to firmly tighten the two Nuts. Diagram 3 D O P B O P Step 4 - Secure Back Leg to Tube and NFCDII Base Place a Washer (Q) between the Tube (G) and the Back Leg (C); then, using an Allen Bolt (N) secure the Back Leg to the Tube. Using the two Allen Screws (S), secure the Back Leg (C) to the NFCDII Base (B). Diagram 4 S B G N Q C Step 5 - Insert Cam Pins into Side Panels There are two holes that are centered on each side of the Side Panels (F), and 12" [304. 3 mm] from each end. Using the phillips screwdriver, screw Cam Pins (K) into the two holes of each Side Panel taking care not to over tighten the Cam Pins. Diagram 5 F K F Step 6 - Insert Cam into Center Support. Place a Cam (J) into each of the four holes in the Center Support (E). Using a phillips screwdriver align each Cam so the arrow is pointing toward the small hole on the edge of the Center Support (See Detail - A). Diagram 6 Cam Hole E Cam - J Cam - J Small Hole Small Hole Detail - A Step 7 - Secure Side Panels to Center Support. The Cam Pins (K) installed in each Side Panel (F) line up with the small holes in the edge of the Center Support (E). The top of each Side Panel is smooth and the bottom has a notch routed in the inside edge. Attach a Side Panel to each side of the Center Support and using a phillips screwdriver, rotate each Cam (J) one-third turn clockwise until secure (See Detail - B). [. . . ] Place the Shelf Pins (R) in to holes in the Side Panels (F) where you want the Glass Shelves (H) to be located. Each Glass Shelf requires four shelf Pins. Place the Glass Shelves (H) in the NFCDII Media Tower. [. . . ]