User manual SANUS PLATINUM FURNITURE DIGTIAL TV STAND-PFV59

[. . . ] PLATINUM FURNITURE MODEL PFV59s Assembly Instructions - Digital TV Stand BUS5306 Congratulations and thank you for purchasing your new Sanus Platinum Furniture Product. If you have any questions regarding this or any other Sanus product, please contact our customer service department at (800)359-5520, or www. sanus. com. It is not necessary to contact the retailer with any questions or problems, as parts can be sent directly to you Please follow these assembly instructions. [. . . ] Note that there are 3 gray and 3 black glides. Use gray glides at front of the base if the stand is going to be placed on a light colored floor. Use Black glides at the front if the stand is going to be placed on a dark colored floor. Left front panel Large wooden dowels x 4 Right front panel x6 Screw 3 connector rods into holes in left and right front panels as indicated above. Press fit 2 large wooden dowels into large holes in left and right panels as shown. Left side panel Right side panel Small wooden dowels x 12 Press fit small wooden dowels into left and right sides as shown above. Right side panel Left side panel x 12 Insert cams into large holes in left and right sides as shown. Make sure arrows on the cams point towards the corresponding cam holes along the edges of the panels. Back x4 Screw 4 connector rods into holes indicated in back panel. Base x4 x2 Screw 4 connector rods into holes in the base as indicated above. Insert 2 cams into large holes in the base as shown above. Left side panel Right side panel Cable duct Press fit the sides to the back as shown above. Press fit 4 cable ducts into large holes in the back as shown. Assistance may be needed for this step. Press fit the sides and back assembly onto the base as shown. Turn the cams clockwise to tighten. C x5 Fasten the back to the base as shown above. x2 D Long rail x2 Assistance may be needed for this step. Hold the long rail in between the sides as illustrated. Insert the black barrel nuts into the holes in the long rail. Ensure the holes in the sides are aligned with the holes in the long rail. Fasten the sides to the long rail as shown. Press fit the front panels to the sides and base as shown. Turn the cams clockwise to tighten. Adjusting screw x 4 Thin side Slide thin sides down slots in front panels and back, ensuring silver surfaces face out. Screw each adjusting screw into sides by half of it's visible threaded length, then once this is done, tighten all 4 Adjusting screws fully into sides. Steel bracket Fit the long steel bracket into the rebate in the long rail and in the grooves in the sides as shown above. Ensure the bracket is equally distanced from the sides on both ends. A x5 Once the bracket is adjusted in the sides, fasten it to the long rail using the screws shown above. [. . . ] Lower the glass onto the shelf pins. NOTE: We recommend that all contents stored in or on this item of furniture be removed before shifting it. The manufacturers will not be held liable for damage caused when furniture is shifted without first removing its contents. If furniture is shifted we recommend that it is lifted not dragged. [. . . ]