User manual SANUS PLATINUM FURNITURE PLASMADLP STAND-PFPLB

[. . . ] PLATINUM FURNITURE MODEL PFPL Assembly Instructions - Digital TV Stand BUS5305 Congratulations and thank you for purchasing your new Sanus Platinum Furniture Product. If you have any questions regarding this or any other Sanus product, please contact our customer service department at (800)359-5520, or www. sanus. com. [. . . ] These loose items should be kept away from young children while assembling your unit. Shelf Pin P840048 x 8 P860121 x 1 P860035 x 6 Barrel nut P840050 x 8 P860015 x 8 Connector rod P820016T x 8 Cam P820015T x 8 Wooden dowel P800201 x 8 P816145 x 4 Cable Ducts P840170 x 2 Insert wooden dowels into sides as shown. x8 1. Fasten 8 Connector Rods into small holes in Top as shown. Intersecting hole Important: *When fitting the rails onto the top, ensure that the grooved part of the rails are closest to the side edges of the top. * The larger holes (cam holes) in the rails must always be closest to the Top. 1. Insert black Barrel Nuts into smaller holes in Rails, ensuring slot in cap is aligned to intersecting hole. Insert silver Cams into larger holes in Rails, ensuring that arrow on Cam points towards intersecting hole. Press fit Rails to Top as shown. Locking screw x8 Base 1. With assistance align Base onto Dowels in Sides & Rails & then press fit. Fasten large Locking screws through Base into Sides & Rails ( Screw heads should be flush with surface). Following steps apply to both flat and curved front designs. Glide x6 Screw x6 1. Fasten the glides to the base as shown. Adjusting screw x 4 1. Screw each Adjusting screw into Side by half of it's visible threaded length, then once this is done, tighten all 4 Adjusting screws fully into Side. Curved edge of the glass shelves must be placed at front for curved front design . Glass shelf Shelf Pin x8 Flat edge of the glass shelves must be placed at front for the flat front design . Insert Shelf Pins into holes at the lower positions of both the Sides (as illustrated above). Tilt and slide Glass Shelf between Rails (ensuring frosted side down) and place on top of Shelf Pins. [. . . ] The manufacturers will not be held liable for damage caused when furniture is shifted without first removing its contents. If furniture is shifted we recommend that it is lifted not dragged. [. . . ]