User manual SANUS STEEL FURNITURE THREE SHELF VIDEO STAND-SFV41

[. . . ] Assembly Instructions for Model: SFV41 Thank you for choosing the Steel Furniture line from Sanus Systems. If you do not understand these directions, or have any doubts about the safety of the installation, please call a qualified contractor or contact Sanus at 800. 359. 5520 or www. sanus. com. Our customer service representatives can quickly assist you with installation questions and missing or damaged parts. [. . . ] CSAV assumes no responsibility for accuracy, completeness or sufficiency of the information contained in this document. Required Tools: Phillips screwdriver Supplied Parts and Hardware: (Threaded fasteners are shown actual size. ) Front Frame - A Qty. 2 Sanus Systems 2221 Hwy 36 West, Saint Paul, MN 55113 06. 05. 06 (6901-100075) Customer Service: 800. 359. 5520. See complementary Sanus products at www. sanus. com Supplied Parts and Hardware Continued: (Threaded fasteners are shown actual size. ) Top Glass Shelf - E Qty. 2 Step 1: Install Feet Shelf Pin - L Qty. 1 NOTE: If necessary, the Feet (G) can be used to level the SFV41 after it is fully assembled. Fully thread two Feet (G) into the bottom of the Front Frame (A) as shown in Diagram 1A. Fully thread two Feet (G) into the bottom of the Back Frame (B) as shown in Diagram 1B. Diagram 1A Diagram 1B A G B G Step 2: Attach Brace Bars to Front Frame NOTE: Do not fully tighten the M6 x 16mm Bolts (H) at this time. Thread a M6 x 16mm Bolt (H) through both holes in the Upper Brace Bar (C) and into the top of the Front Frame (A) as shown in Detail A of Diagram 2, securing the Upper Brace Bar to the Front Frame. Thread a M6 x 16mm Bolt (H) through both holes in both Lower Brace Bars (D) and into the bottom of the Front Frame (A) as shown in Detail B of Diagram 2, securing the Lower Brace Bars to the Front Frame. Diagram 2 Detail A A C H Detail B A D H Step 3: Attach Back Frame Thread a M6 x 60mm Bolt (I) through a M6 Washer (J), the Back Frame (B) and into the backs of the Upper Brace Bar (C) and both Lower Brace Bars (D) as shown in the Diagram 3. Make sure the Front and Back Frames (A & B) are straight and level; then, using the Allen Key (N), tighten the three M6 x 60mm bolts (I), and the six M6 x 16mm Bolts (H) from Step 2. Diagram 3 A C B J I D Step 4: Installing Middle Glass Shelf Determine the desired height of the Glass Shelf (F). [. . . ] Place the Top Shelf (E) on top the Front and Back Frames (A & B); then, place the Glass Shelf (F) so that it is resting on the Lower Brace Bars (D) and the crossbar of the Front Frame (A) as shown in Diagram 5. Detail A M A Detail C B Detail D E Diagram 5 Detail B M M F D M Sanus Systems 2221 Hwy 36 West, Saint Paul, MN 55113 06. 05. 06 (6901-100075) Customer Service: 800. 359. 5520. See complementary Sanus products at www. sanus. com [. . . ]