User manual SANUS ULTIMATE FOUNDATIONS-UF22 UF26 UF30 UF34

[. . . ] Using hardware that is too long may damage your monitor's internal components. Make sure vertical brackets [06] will be equally spaced top to bottom on the TV and that they will be level. If you require spacers, determine if you will need the short [22] or the long spacers [23]. Fit the shoulder washer [26] into the slots and holes of the front side of the vertical brackets [06] and snap the appropriate length spacer onto the shoulder washer [26] from the back (TV) side. [. . . ] Position the assembly over the TV and slide the vertical brackets [06] left or right until they are over the mounting holes in the back of the TV. Ensure that the bracket is level on the back of the TV. For special applications, or if you are uncertain about your hardware selection, contact Customer Service. Ensure that the bracket is level on the back of the TV. For special applications, or if you are uncertain about your hardware selection, contact Customer Service. Install TV Bracket for TV's with flat backs Before you begin, hand thread screws into the threaded inserts on the back of your TV to determine the correct screw diameter (M4, M5, M6, or M8). verify that there are adequate threads to secure the brackets to the monitor. If you encounter resistance, stop immediately and contact customer service. Use the shortest screw and spacer combination to accomodate your needs. Using hardware that is too long may damage your monitor's internal components. Using the wall plate template[01], Level the template [01] and mark the hole locations. Tighten the lag bolts [36] only until the washers [35] are pulled firmly against the wall plate [08]. Install the wire management assembly and wall plate covers onto the wall plate. Mount the upper cover [07] using the 1/8 in. hex key [27] to install four screws [31]. Mount the lower cover [07] using the 1/8 in. Hex key [27] to install four screws [31] while fitting the rear mount of the wire managment assembly [09] between the cover [07] and the lower horizontal of the wall plate [08]. Install the front mount of the wire management system to the back side of the face plate of the wall plate [08] using two screws [31]. You will need assistance with this step. Hang the TV with mounting bracket assembly onto the face plate of the wall plate [08]. [. . . ] Hang the TV with mounting bracket assembly onto the face plate of the wall plate [08]. The upper knobs of the mounting bracket assembly will drop into the top slots of the face plate of the wall plate [08]. Secure the TV to the face plate of the wall plate [08] by installing the locking screws [32] with the 3/16 in. Slide the three covers of the wire managment assembly [09] off the front (face plate mount), rear (wall plate mount), and center (floating). [. . . ]