User manual SANUS VISIONMOUNT FLAT PANEL WALL MOUNT-VMPL

[. . . ] Check carefully to make sure that there are no missing or defective parts. sanus Systems can not be liable for damage or injury caused by incorrect mounting , incorrect assembly , or incorrect use. Please call Sanus Systems before returning products to the point of purchase. The weight of the monitor must not exceed 20 lbs (9 kg). [. . . ] Improper installation may cause property damage or personal injury. Do not use this product for any purpose that is not explicitly specified by Sanus Systems. If you do not understand these directions, or have any doubts about the safety of the installation, please contact Sanus at +31 -(0)40 26 68 619 or www. Our customer service representatives can quickly assist you with installation questions, and missing or damaged parts. Replacement parts for products purchased through authorized dealers will be shipped directly to you. Check carefully to make sure that there are no missing or defective parts. sanus Systems can not be liable for damage or injury caused by incorrect mounting , incorrect assembly , or incorrect use. Please call Sanus Systems before returning products to the point of purchase. Step 1: Adjust the Pillar Clamp Height for Thicker Desk Surfaces (optional) CAuTION: Do not adjust the height of the Pillar with a monitor attached. Sanus Systems is not responsible for property damage and/or personal injury. Place the four screws through the Monitor Mount and the spacers, and then into the VESA bolt mounting pattern on the back of the monitor. Step 3: Attach the Monitor Mount to a Monitor with a Flat Back NOTE: For monitors with curved backs or obstructions, go to Step 4. Attach the Monitor Mount [B] to the back of your LCD monitor using the M4 x 10 mm Screws [E], as shown in Figure 3. Position the Monitor Mount so that the large side of the tapered hole faces the bottom of the monitor. Place the four screws through the Monitor Mount into the VESA bolt mounting pattern on the back of the monitor. Step 6: Cable Management Place the monitor cables into the channel on the back of the pillar [A]. Snap the cable cover [C] into the grooves along the edge of the channel, as shown in Figures 6a and 6b. Step 7: Adjust Pillar Height (Optional) CAuTION: Do not adjust the Pillar height if a monitor is attached. Sanus Systems is not responsible for property damage and/or personal injury. Remove the Cable Cover [C] from the Pillar [A], and lift the monitor cables out of the channel on the Pillar. [. . . ] Sanus Systems is not responsible for property damage and/or personal injury. Remove the Cable Cover [C] from the Pillar [A], and lift the monitor cables out of the channel on the Pillar. See Step 5 for additional details about how the Monitor Mount and Pillar fit together. Loosen the two screws at the top of the Pillar with a Phillips screwdriver. [. . . ]