User manual SANUS VISIONMOUNT TILT AMP SWIVEL CEILING MOUNT-LC1A

[. . . ] NOTE: This mount is not intended for use on brick, concrete block, concrete, or steel wall studs. Typical wall anchors do not have sufficient holding power to support this mount. It is up to the installer to verify the safety of any installation method or hardware that is not provided by or recommended by Sanus Systems. Sanus Systems makes every effort to assure all necessary television mounting hardware is included. [. . . ] See complementary Sanus products at www. sanus. com M4/M5 Spacer - L Qty. 1 Step 1: Mount the Wall Plate: Wood Stud installation only CAUTION: Do not overtighten the Lag Bolts (P). Tighten Lag Bolts until the Lag bolt Washer (Q) is pulled firmly against the Wall plate (A). If there is a layer of drywall or other material, this drywall or other material may not exceed 5/8 inch [15. 8 mm] in thickness. Failure to heed this caution may result in property damage and/or personal injury. Wood Stud Mounting: The Wall Plate (A) must be mounted to a wood stud. Use a high quality stud sensor to locate a stud. It is a good idea to verify where the stud is located with an awl or thin nail. Pre-drill a 2. 5" [63. 5 mm] deep hole at the desired height in the stud using a 3/16" drill bit. Make sure the hole is in the center area of the stud. Use this location for the middle hole in the Wall Plate. A loose Safety bolt will result in an unstable installation which may result in property damage and/or personal injury. Thread a Safety bolt (S) into the threaded hole on each side of the Transfer Bracket and tighten them with a phillips screwdriver until they are tight. See the detailed View of Diagram 5 for assistance. Diagram 5 Detailed View Transfer Bracket S NOTE: Lower Hole on transfer bracket may be used to add a padlock for added security. Step 6: Leveling and Adjusting Tension on the Monitor CAUTION: Do not remove the Tension Nuts labeled in Diagram 6a. Removing Tension Nuts may result in property damage. Once the television is mounted onto the Wall Plate (A), and the Safety Bolts (S) are tight, it can be adjusted to level. Slightly loosen the two Allen Bolts on the back of the Arm Assembly (B). Once those two bolts are loosened, the television can be adjusted ±6º until level. When the television is level retighten the two Allen Bolts. The tilt can be adjusted by simply tilting the television. If you need to adjust the tension of the tilt, you can do so with the Tension Knobs. The Tension Nuts labeled in Diagram 6a can be slightly loosened or tightened to adjust the tension of the Arm Assembly. [. . . ] Diagram 6a Safety Bracket Tension Nut B Diagram 6b Safety Bracket Allen Bolts Tension Knobs Tension Nut Step 7: Cable/Wire Management CAUTION: Do not run cables through a pinch point. Running cables through pinch points may result in damage to the cables and/or personal injury. Before beginning cable management pull the television into the position as far from the wall as possible. Leave some slack in the cables so that during motion so there is no added tension on the connectors. [. . . ]