User manual SANUS VLF311

[. . . ] Install brackets to TVs with irregular or obstructed backs Before you begin, hand thread screws into the threaded inserts on the back of your TV to determine the correct screw diameter (M4, M5, M6, or M8). verify that there are adequate threads to secure the brackets to the monitor. If you encounter resistance, stop immediately and contact customer service. [. . . ] Ensure that the bracket is level on the back of the TV. If you need extra space to accommodate cables, recesses, or protrusions, see an installation option (1-1 or 1-2) that uses spacers. For special applications, or if you are uncertain about your hardware selection, contact Customer Service. Lock the horizontal brackets [02] and [03] in place with 4 screws [32] using the 3/16" hex key [29]. Wall Mounting For assistance in determining wall plate location, see Height Finder at sanus. Improper use could reduce the holding power of the lag bolt. Any material covering the wall must not exceed 16 mm (5/8 in. Improper use could reduce the holding power of the lag bolt. Be sure the anchors [34] seat flush with the concrete surface. Mount wall plate directly onto the concrete surface. Never drill into the mortar between blocks. To prepare the wall plate for mounting: Slide the arms of the wall plate [08] together and insert the slide lock [33] into place. This will lock the arms into full extension making the wall plate mounting and TV attachment easier. Verify the center of the stud with an awl or thin nail or use an edge to edge stud finder. [. . . ] Adjustments Adjust up/down tilt tension by hand or using the M3 hex key [28]. Storage After setup is complete, remove slide lock from the locking position A and fit it into the grooves of one of the slides for storage B. Milestone AV Technologies and its affiliated corporations and subsidiaries (collectively, "Milestone"), intend to make this manual accurate and complete. [. . . ]