User manual SANUS WOODBROOK FURNITURE AUDIO STAND-WFA37

[. . . ] Check carefully to make sure that there are no missing or defective parts. Our customer service representatives can quickly assist you with installation questions and missing or damaged parts. Replacement parts for products purchased through authorized dealers will be shipped directly to you. [. . . ] Tighten each Cam closest to the Side Panel in a clockwise motion until the stretchers are secured. Note: Front stretchers attach to the same side as the hinge holes are on. Diagram 3 Detailed View a s d b hinge holes p Step 4: Add Side Panel Press fit the Side Panel (t) against the Stretchers (o, p) so the Cam Pin (a) goes into the hole which the Cams (b) point to. The Dowel (d) fits into the adjacent hole. Tighten each Cam in a clockwise motion until the Stretchers are secured. Note: Make sure the hinge holes on the Side Panel are on the same side as the Front Stretchers. Diagram 4 Detailed View p b o t hinge holes a Step 5: Add Shelf Pins and Bottom Shelf Thread the Shelf Pins (e) into the bottom hole in the line of holes in each Side Panel (s, t). Tighten all four Shelf Pins with a Phillips screw driver. Add the Bottom Shelf (q) by inserting it into the assembly and press fit it onto the Shelf Pins. Make sure the Bottom Shelf is flush against the Front Stretcher (o). If there is a gap in front, the shelf may be backward. Diagram 5 Detailed View s e q q t Step 6: Add Top Gently tap a Dowel Pin (c) into the holes on the top of each Side Panel (s, t). Press fit the Top (n) so it fits onto the Dowel Pins. Diagram 6 Detailed View s t n c g t Step 7: Add Door Handle Insert each Phillips Bolt (h) through the Door (v) and into the Door Handle (i). The Door Panels can be interchanged by removing and re-installing the plastic border from the perimeter of the Door's back side. Diagram 7 Detailed View i v h Step 8: Add Hinge Assembly to Door Insert a Hinge Screw (j) through the Hinge (l) and thread it into the Door (v). Tighten each with a Phillips screw driver. Repeat process until both Hinge Assemblies are secured. [. . . ] Note: Sanus recommends placing components and installing all cables/wires before putting the Back Panel on. Detailed View Diagram 11 u p f Step 12: Hinge Adjustment for small Door Each hinge Assembly is adjustable in multiple directions. Diagram 12 Side Adjustment Depth Adjustment Height Adjustment Sanus Systems 2221 Hwy 36 West, St. [. . . ]