User manual SANUS WOODBROOK FURNITURE AV STAND-WFAV66

[. . . ] Paul, MN 55113 12. 28. 05 Customer Service: 800. 359. 5520. See complementary Sanus products at www. sanus. com Parts List (Cont) (3) Bottom Shelf - q (9) Mid Shelf - r (3) Door - s (2) Wood Panel Insert - t (3) Back Panel - u (1) Left Side Panel - v Step 1: Prepare the Side Panels (1) Right Side Panel - w (2) Center Panel - x Thread a Cam Pin (a) into each of the smaller holes in each Side Panel (v, w). Tighten each Cam Pin with a Phillips screw driver. Insert a Dowel (d) into the larger adjacent hole in the Panels. [. . . ] The Dowel (d) goes into the adjacent hole. Make sure the stretchers are oriented so the Cams face inward. Tighten each Cam closest to the Center Panel in a clockwise motion until the stretchers are secured. Note: Front stretchers attach to the same side as the hinge holes are on. Diagram 6 Detailed View x a b hinge holes d p Step 7: Add Second Center Panel Press fit the Center Panel (x) against the Stretchers (o, p) so the Cam Pin (a) goes into the hole which the Cams (b) point to. The Dowel (d) fits into the adjacent hole. Tighten each Cam in a clockwise motion until the Stretchers are secured to the Center Panel. Note: Make sure the hinge holes on the Center Panel are on the same side as the Front Stretchers. Diagram 7 Detailed View o a x hinge holes d Step 8: Add Stretchers Add the Front and Back Stretchers (o, p) to the Center Panel (x), by aligning the Cam Pin (a) with the hole which the Cams (b) point to. The Dowel (d) fits into the adjacent hole. Make sure the stretchers are oriented so the Cams face inward. Tighten each Cam closest to the Side Panel in a clockwise motion until the stretchers are secured. Note: Front stretchers attach to the same side as the hinge holes are on. Diagram 8 x a Detailed View d hinge holes o Step 9: Add Side Panel Press fit the Side Panel (w) against the Stretchers (o, p) so the Cam Pin (a) goes into the hole which the Cams (b) point to. The Dowel (d) fits into the adjacent hole. Tighten each Cam in a clockwise motion until the Stretchers are secured to the Side Panel. Note: Make sure the hinge holes on the Side Panel are on the same side as the Front Stretchers. Diagram 9 Detailed View o w a Step 10: Add Shelf Pins and Bottom Shelf Thread the Shelf Pins (e) into the bottom hole in the line of holes in each Panel (v, w, x). Tighten Shelf Pins with a Phillips screw driver. Add the Bottom Shelf (q) by inserting it into the assembly and press fit it onto the Shelf Pins. Make sure the Bottom Shelf is flush against the Front Stretcher (o). If there is a gap on the front side the shelf may be installed backward. [. . . ] Insert each Mid Shelf (r) into the assembly and press fit onto the Shelf Pins. Make sure the wood strip on each shelf is facing toward the front. Note: Diagram 14 is a Back View. Detailed View e v Diagram 14 x x r w Step 15: Add Back Panel Position each Back Panel (u) up against the assembly and thread a Wood Screw (f) through it and into the Back Stretcher (p). Repeat process until each Back Panel is secured with four Wood Screws. [. . . ]