User manual SANWA SUPER EXZES

[. . . ] Note: The spring tension is factory set at the lowest (softest) position. Driving Position 1. Remove the 4mm hex socket head cap screws on each side of the transmitter using a 3mm hex wrench. Detach the grip downward from the upper transmitter unit. Be careful to avoid damaging the lead wires that are connected on both units. [. . . ] When entering a character in a position occupied by a space, a group can be selected from the preceding character by first pressing the Dec. /- key. This is useful when entering several characters from the same group. Page 23 Model (Cont) [COPY/CLEAR] Model Copy / Model Clear This function enables you to copy data from the currently selected model to another, or to copy another model's data into the model currently selected. Data can be cleared (initialize) on the current model that is selected. COPY MODEL DATA 1. Using the function select keys, move the cursor to [COPY/CLEAR] in MODEL. To copy data from the current selected (Master) model to another model (Slave), use the INC/+ or DEC/- keys to change the model numbers up or down to the model number you would like to copy the current model (Master) to. After you have selected the model number you wish to copy the current model (Master) to, press the ENTER key. The screen will now change and ask you: YES=<INC> and NO=<DEC> Press the INC/+ key to copy the current (Master) model to the new model (Slave) you have selected. Press the DEC/- key to return to the previous screen. To copy data from another model to the one you are currently using, use the key to change the current model (Master) to (Slave). In turn the model you would like to copy from will now show (Master). The (Master) will always overwrite the (Slave). If the sub-trim and main trim settings are both offset to one side, an operational dead spot (a spot where the servo does not operate) may result. Page 25 Timer Three types of timers are provided for measuring lap, interval, and down (or up) times, and these three timers can be used simultaneously. A high degree of freedom and convenience is provided by the ability to use the key assign switch to perform simultaneous or independent operation. Separate tones can be assigned to each of the timers, making it easy to distinguish between them during simultaneous operation. Page F2 (TIMER) The audible signal provided by the tone is complemented by a vibrator, which can be set to operate either in concert with the tone, or simultaneously. The operational status of the timers can also be checked from other menus (in the constant display area). [LAP] Lap Timer This feature allows you to measure and record times for up to 99 laps. It features a pre-alarm (PRE-ALM) that lets you set a pre-goal alarm time. Provides real-time display of the best lap (BEST), average lap (AVE), and total (TOTAL) lap times. Using the function select keys, move the cursor to [TH] in TIMER. Turning the lap timer (ON/OFF) Be sure that the cursor appears below LAP, and then press Inc. + or Dec. - to set the timer ON or OFF. Press the ENTER key to move the cursor to GOAL, and then set the goal time by pressing the Inc. + or Dec. - key. Setting range 00'10 to 60'00 In 00'10 increments (Default setting 60'00) Setting the pre-alarm (PRE-ALM) 4. Press the ENTER key to move the cursor to PRE-ALM, and then set the prealarm by pressing the Inc. + or Dec. - key. [. . . ] - The receiver susceptible to vibration, shock and moisture. Take appropriate measures to protect against vibration and water. Failure to take appropriate measures could result in runaway operation or to damage to the receiver. - Keep the receiver antenna away from motors, battery, and ESC and make sure that antenna stick out from the model vehicle vertically. [. . . ]