User manual SANYO AVM-3280G

[. . . ] If this equipment causes harmful interference to radio or television reception which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for help. [. . . ] The projector may not be connected to the network. Please check the connection and network configuration of this projector. The PIN code for the multi-controlled projectors must be the same. Change the PIN code of this projector to the common PIN code. Check if this projector is using the Network Capture function or Network Viewer function individually, or in the standby mode. * The network unit updates the status at the time when the multi-control function was executed. If the multi-controlled projector is in the standby mode, any change is not effective except timer setting. Cannot register, delete or change the multi-control setting during using the network viewer function. It is recommended that a specified projector should be chosen for setting as a master when you use this multi-control function. The control for the multi-controlled projectors will become too complicated operation if this function is used for each projector. If the registered projector is not connected to the network, it will take some time to complete the multi-control operation because of waiting for the response from each registered projector. There are some disabled items in the multi-control function for the light mode. PJ-NET ORGANIZER OWNER'S MANUAL 65 ENGLISH Chapter 4 Controlling the Projector Conf. & Change page in the light mode Following functions in the "Conf. Start communication . . . . . . . . . . . . . . . . . . . . Starts the Network Communication. (p. 77) Captured image is projected on the screen. The captured image edit window appears on the computer screen. Parameter set up. . . . . . . . . . . . . . . . . . . . . . . . . . . . Sets the communication parameter between the computer and network unit of the projector. For further information, see item "Parameter set up" below. (p. 71) Version information. . . . . . . . . . . . . . . . . . . . . . . Displays the version of this software. Shut down . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Quits the application. Parameter set up 1 Click Network Capture 3 icon on the task bar. 2 Click "Parameter set up" on the popup menu. The set3 Set Capture Port and PIN code to match to the projector's port number and Network PIN code. see item "Control by the web browser" ( p. 74). To check the PIN code, see item "Network PIN code setting" ( p. 22). There are some reserved port numbers and also some applications may use their own port numbers. [. . . ] Rule3 The IP address must correlate to a network number. If network numbers are different between the equipment, they cannot establish communications each other. In this case, the router is placed in the networks to make the routing. Q What is the MAC address assigned to the network unit?A The MAC address is indicated on the case back as the below. MAC Address MAC address PJ-NET ORGANIZER OWNER'S MANUAL 129 ENGLISH Chapter 8 Appendix Network capture Q Why doesn't the computer screen appear on the projected screen? [. . . ]