User manual SANYO CE42LM6WP

[. . . ] INSTRUCTION MANUAL LCD Monitor CE42LM6R CE42LM6DPB CE42LM6WP CE42SR2 CE52LH2R CE52LH2WP CE52SR2 Please read this Instruction book before using your LCD monitor. We wish you many hours of pleasure from your new LCD monitor. GB TABLE OF CONTENTS GB TABLE OF CONTENTS . 4 Federal Communications Commission Notice . 7 Remote control battery installation . [. . . ] Input/d button: Switch between AV1, RGB, AV2, AV3, PC , DVI or Network mode . It is also used to provide sub menu selection from the Main Menu . 1 or 2 buttons: provide up and down adjustments . 4 button: To switch to standby mode (to switch off completely disconnect the monitor from the power supply) . 2. Brightness and the 1 or 2 button to adjust levels . May be used to adjust the color tone of the picture . Use the 5 or 6 button to select White Tone and press the 1 or 2 button to enter the sub menu . You can select Personal, Cool, Standard or Warm settings by using the 1 or 2 button . To adjust the color tone of the picture by using the 5 or 6 button to select Red(R), Green(G) or Blue(B) and the 1 or 2 button to adjust levels . These settings will be stored in personal mode automatically . n White Tone 8 GB Picture menu n Advanced settings MENU OPERATION n Current Weekday n Current Time Use to set the current time using the Numeric buttons . Use to set current weekday using the 1 or 2 button . GB Use the 5 or 6 button to select Advanced settings and press the 1 or 2 button to enter the sub menu as follows . Other items in Time Menu should not be selected until Current Time has been set . n Schedule Use to set up to 20 separate time schedules for "Power On" or "Power Off", select 1 ~ 20 using the 1 or 2 button . DCDi (Directional Correlational Deinterlacing) is used to process moving angled edge in deinterlacing to get the smoothest and most natural image . Press the 1 or 2 button on the remote control to select On or Off . ACC/ACM (ACC: Adaptive Contrast and Color; ACM-II: Active Color Management-II) is used to select adaptive Brightness, Contrast and tone control . Press the 1 or 2 button on the remote control to select suitable mode either Vivid, Cinema, Sport or Off . CCS (Cross Color Separation) is used to remove residual chroma information from luminance signal which is the result of imperfect decoding of composite video . Press the 1 or 2 button on the remote control to select either Auto, Standard or Off . DNR (Digital Noise Reduction) is available for noise reduction . Press the 1 or 2 button on the remote control to select either Auto, Low, Mid, High or Off . MPEG NR (MPEG Noise Reduction): Removes unwanted ringing and block noise from images that have undergone MPEG or JPEG compression and decompression . Press the 1 or 2 button on the remote control to select On or Off . Film Mode (Inverse 3:2 pulldown): Film vs . Video-Detect film . Performed on material which underwent technologic conversion to video . [. . . ] Status of MPEG NR setting . n PC Read Command Table Status read command CR H-POS CR V-POS CR PHASE CR CLOCK Item Status of Horizontal position . Status of CLOCK value . n Input Read Command Table Status read command CR INPUT CR SOURCE CR SYSTEM Item Status of Input selection . Status of system of Input mode . n Screen Read Command Table Status read command CR SCREEN Item Status of screen size . (The same of WIDE mode) 18 GB n Time Read Command Table Status read command CR PANELH CR MONH Item Status of accumulated lifetime of panel . [. . . ]