User manual SANYO CLT9915 INSTRUCTION MANUAL

[. . . ] INTRODUCTION Congratulations on your purchase of this Sanyo cordless telephone. Your Sanyo 900-MHz cordless telephone is a fine-quality home communications product. It is carefully designed and produced by a world leader of consumer and industrial electronics equipment. With proper maintenance and care, it will provide you with years of enjoyment and convenience. [. . . ] When you hear the access tone, press MEM again and then press 8. At the next access tone, press MEM and then 9. Tip: Wait for the access tones between pressing MEM, or your call might not go through. Memory Location 7 8 9 Make sure the telephone is off before you replace the battery. Slide off the battery compartment cover. Disconnect the battery plug from the jack in the compartment and remove the battery. Insert the new battery and connect the cord into the jack. Put the battery compartment cover back on. Note: If the handset battery is removed for more than 5 minutes, the speed dial memory will be erased. Charge the handset battery for 12 continuous hours prior to first use. Caution: To reduce the risk of fire or personal injury, use a 3. 6V, 600 mAh battery. Power Failure During the period that the power is off, you will not be able to make or receive calls with the telephone. After a power outage, place the handset in the base for about 20 seconds to reset the digital security code. Dial tone is OK, but cannot dial out · Make sure the tone/pulse setting is programmed correctly. Handset does not ring · Make sure the RINGER switch on the handset is turned to ON. · You may have too many extension phones on your line. · See solutions for No dial tone. You experience static, noise or fading in and out · · · · · Change channels, Is handset out of range?Make sure base is not plugged into an outlet with another household appliance. NOTICE: This equipment meets the applicable Industry Canada Terminal Equipment Technical Specifications. This is confirmed by the registration number. The abbreviation, IC, before the registration number signifies that registration was performed based on a Declaration of Conformity indicating that Industry Canada technical specifications were met. or to an authorized Sanyo Service Depot when you make a claim under this warranty. You, the original retail purchaser, are responsible for any costs of TRANSPORTING the product to and from SANYO Canada Inc. [. . . ] Base is installed in the basement or lower floor of the house. Base is plugged into an AC outlet with other electronic devices. Baby monitor is using the same frequency. Handset is out of range of the base. SANYO Canada Inc. [. . . ]