User manual SANYO DMP-P3

[. . . ] 11. ) Keep the player clean and never store it next to a heat source or in dirty, humid or wet places. 12. ) Do not block any ventilation openings; the ventilation should not be impeded by covering the ventilation openings with items, such as newspapers, table-cloths, curtains, etc. Give minimum 10cm distance around the apparatus for sufficient ventilation. 13. ) To prevent fire or shock hazard, do not expose this unit to rain or moisture. [. . . ] Protect Your Furniture This model is equipped with non-skid rubber 'feet' at the bottom of the unit to prevent the product from moving when you operate the controls. These 'feet' are made from non-migrating rubber material specially formulated to avoid leaving any marks or stains on your furniture. However certain types of oil based furniture polishes, wood preservatives, or cleaning sprays may cause the rubber 'feet' to soften, and leave marks or a rubber residue on the furniture. To prevent any damage to your furniture we strongly recommend that you purchase small self-adhesive felt pads, available at hardware stores and home improvement centers everywhere, and apply these pads to the bottom of the rubber 'feet' before you place the product on fine wooden furniture. -3- Power Source This product is designed to operate on normal 240V~50Hz AC power only. Do not attempt to operate the unit on any other power source. You could cause damage to the product that is not covered by your warranty. AC Power Supply Connection 1. Check the rating label located at the bottom of the unit corresponds to your local mains supply. Make sure the wall socket is switched off, then plug the AC plug into the wall socket. CAUTION: The device is connected to the mains with the AC plug. Disconnect the AC plug from the wall socket if you want to completely disconnect the device from the mains. Make sure the power plug is easily accessible during operation and not hindered by other objects. Install 1 x 9V/6F22/006P/PP3 type battery (not included) into the back up battery compartment located at the bottom of the unit (Alkaline batteries are recommended for longer life time). Be sure to observe the polarity markings, and then close the battery compartment cover. In the event of AC Power cut off, the backup battery maintains the time settings. Battery Precautions Follow these precautions when using batteries in this device: 1. Use only the size and type of batteries specified. Be sure to follow the correct polarity when installing the batteries as indicated in the battery compartment. Reversed batteries may cause damage to the device. If the device is not to be used for a long period of time, remove the batteries to prevent damage or injury from possible battery leakage. Do not try to recharge batteries not intended to be recharged; they can overheat and rupture. (Follow battery manufacturer's directions. ) 5. Do not disassembly it. Do not dispose of the old battery in a fire. -4- OVERVIEW FRONT VIEW TOP VIEW REAR VIEW -5- SIDE VIEW BOTTOM VIEW -6- GENERAL FUNCTIONS Switching On and Off 1. The unit will automatically switch to standby mode once the AC power source is connected. [. . . ] Increase volume Power cord incorrectly Connect power cord correctly. The device does not Electrical static discharge. Switch off the respond to button device, disconnect the mains commands cable and plug it in again after a few seconds. Poor radio reception Weak radio signal FM: Extend the FM antenna to its full length or try to change the postion and direction of the FM antenna. [. . . ]