User manual SANYO DMP-P7

[. . . ] INSTRUCTION MANUAL DMP-P7 Clock Radio with dock for iPod iPod is a trademark of Apple Inc. , registered in the US and other countries. PRECAUTIONS Please take good note of the following instructions: The unit must be connected to the power voltage which is the same as the local area. If not, there is a danger of "burning" the unit that causes a fire. Do not expose to the temperature higher than 35OC. Avoid installation near heaters or in areas subjected to direct sunlight. [. . . ] Replace the battery holder back in the remote control. A B Battery door latch NOTE: PLEASE DISCARD BATTERIES PROPERLY The Remote Control controls basic functions on the clock radio. For best results, aim remote control towards the grill by the lower right corner of the display. 23 25 27 29 31 33 ST/ MONO BAND/ RADIO 24 26 28 30 32 34 23. 29. POWER ON/OFF Button MUTE Button PRESET Button SLEEP PROG Button BAND/RADIO Button ST/MONO Button Turns clock radio ON or OFF or reset alarm when alarm is sounding Mutes the sound Selects preset radio stations Selects sleep function Stores radio program This button switches between AM and FM radio bands. Switches the receiver between FM stereo and mono modes. Mono reduces the noise heard when listening to weak FM stations. Skip to previous or next track when iPod is playing, or HOLD to scan current playing track. Lowers volume level Raises volume level 30. VOLUME + Button 6 Clock Display AM Indicator TIME/ALARM Display Alarm 2 Armed Alarm 1 Armed iPod Indicator Wake To Indicator: iPod, Radio, Buzzer, SHUFFLE Indicator PRESET Indicator ST/KHz/MHz FM Indicator SLEEP Indicator Indicator PM Indicator Radio Frequency/Date/ Volume Level/AUX Display 7 Setting Up the Clock Radio Setting Clock Time and Calendar 1. Press and hold the CLOCK Button located on the back of the unit until 12H or 24H appeared. Select your desired clock display either 12 hour or 24 hour by pressing SKIP FORWARD or BACKWARD Button repeatedly. Then press the CLOCK Button again to confirm 12H or 24H mode setting. The clock display at the centre will flash. Press the SKIP FORWARD or BACKWARD Button to set the current time, then press the CLOCK Button again to confirm clock setting. (Note: if the system is set to 12hour mode, if it's afternoon, the PM indicator will be lighted on. ) 3. The year display at the lower right will flash. Press the CLOCK Button to accept the current setting, or press the SKIP FORWARD or BACKWARD Button until current year is displayed. Press the CLOCK Button to confirm year setting. The date display at the lower right will flash. Press the CLOCK Button to accept the current setting or press the SKIP FORWARD or BACKWARD Button until current date is displayed. Press the CLOCK Button to confirm date setting. Setting Alarm Time 1. Press and hold the ALARM 1 Button or ALARM 2 Button until the display flashes. Press the SKIP FORWARD or BACKWARD Button until the desired alarm time is displayed. [. . . ] When the display changes back to show the real time, pressing the SLEEP Button once will show the sleep time remaining. Pressing it again will change sleep time to the next lowest increment. Clock radio has independent volume setting for sleep for sleep mode so you can adjust the sleeping volume without affecting the alarm volume. Press the VOLUME UP or DOWN (or press Volume+ and VolumeButton on the remote control) to adjust sleep volume. [. . . ]