User manual SANYO DP42848

[. . . ] Check no part is missing, or no mounting part is loose. Some parts are not used for installation or replacement. Note : figures in this manual may be differ from the actual product. -1- LENS REPLACEMENT AND INSTALLATION PROCEDURE 1 T urn off the projector, press the Main On/Off Switch to Off and unplug the AC power cord from the AC outlet. T urn the Lens Mount Cover counter-clockwise and take it off by pulling forward. [. . . ] 1) 5 This projector can use three (3) different types of Light-Block Plates, use the Light-Block Plate that corresponds to the appropriate optional lens. NOTE: Make sure the shape of the Light-Block Plate is correct. Make sure the mark (UP/DOWN and FRONT/ BACK) on Light-Block Plates are correct and set them properly. Light-Block Plate Type FK2A (610 337 0064) 2 Lens Mount Cover Fig. 1 NOTE: The Light-Block Plate FK2A is separated to the upper and lower plates. UP Upper Plate Lower Plate 3 Remove 2 Screws A and loosen 2 Screws B. Slide the Top Cover forward to take off. 2) Top Cover A A B B DOWN Insert the lower Light-Block Plate. 2 4 Remove the Cover Plate by lifting upwards. 9-2) 10 I nstall the Upper Light-Block Plate into the guide of Lower Light-Block Plate. 10) Note: When installing the Upper Light-Block Plate, the Lower Light-Block Plate should be lifted upward with your hand. Hang the ditch on Lower Light-Block Plate to the Upper Light-Block Plate. Make sure the mark (UP/DOWN and FRONT/ BACK) on Light-Block Plate is correct and set them properly. Lower Plate Upper Plate Safety Clamp (SC-A) Part No. 9-1 R eplace and fix the Top Cover with two (2) Screws A and 2 screws B. 11) Top Cover A A Safety Clamp Attached Figure B Safety Clamp (SC-A) Part No. (610 322 3742) Lens Lock Lever B Fig. 9-2 -4- 12 Fit the raised dot of the Lens Mount Cover to the leftmost edge of the Seal on the projector, and then turn the Lens Mount Cover clockwise and adjust the position of the raised dot to the one of the projector. [. . . ] 9-2 -4- 12 Fit the raised dot of the Lens Mount Cover to the leftmost edge of the Seal on the projector, and then turn the Lens Mount Cover clockwise and adjust the position of the raised dot to the one of the projector. 12) NOTE: If not mounted properly, the Lens Mount Cover may fall, causing hazards of injuly. Label Dot on the cabinet Dot on the lens mount cover FOCUS CORRECTION When the lens is attached to the projector and images are being projected onto the screen, the peripheral focus may be out of focus in some localized areas. If this happens, insert the one, of three sizes of spacers, in between the Lens Attachment and the lens to adjust the focus. [. . . ]