User manual SANYO DVPP1EX

[. . . ] Floor: The system should be installed on a smooth, hard, and level floor surface. Floor pitch should not exceed 1 inch in 5 feet. Operating Environment The unit to be installed is an Insulation Catagory Type II machine and operates in a Pollution Degree 2 environment in accordance with IEC 664 ( Normal Office Environment ). Description Temperature* Specification 15. 5-26. 6°C (60-80° F) for unplumbed systems15. 5-30° C (60-86° F) for plumbed systems 15-76% 0-2000 metres (6562 feet) maximum of 325 lux ** (30. 2 foot-candles) Relative Humidity Altitude Lighting * Room temperature changes of more than 5 degrees during operation will require recalibration of the PRINTER. [. . . ] and Canada, amperage for the PRINTER is 16A, and the amperage for the PROCESSOR is 32A. Note To prevent processor failures caused by power fluctuations, purchase a Square-D Buck and Boost Transformer (Model #500SV43F) EK Catalog #869-7799. Other transformers may not provide satisfactory results. Within the US and Canada, the PRINTER is supplied with a 2. 4-metre (8-foot) POWER CORD. The power receptacle must be located within 1. 2 metres 30 cm (4 feet 1 foot) of the rear of the PRINTER. This power receptacle should be a dedicated line with a separate CIRCUIT BREAKER. The receptacle must accept a PLUG which conforms to NEMA N6/15 (printer plug specification). Outside the US and Canada, the region will supply the appropriate locally approved POWER CORD and PLUG. The POWER CORD should be cretified and approved by a national test house. Within the US and Canada, the PROCESSOR is supplied with a 2. 4-metre (8-foot) POWER CORD which enters the cabinet from below. Locate SCSI-2 CABLES away from any source of electrical interference (e. g. transformers, fluorescent light ballast). 6 23NOV99 ­ SS2616-1 Site Specifications Plumbing Requirements Water Supply: Adequate water supply and drainage is the customer's responsibility, and must be installed to specifications by the customer before installation of the PROCESSOR begins. A WATER SUPPLY PANEL for plumbed systems is available from Kreonite (WPS-A), and is recommended. Kodak will install flexible supply line to PROCESSOR and an electrical connection to the SOLENOID. The WATER SUPPLY PANEL should be wall-mounted within 4. 9 metres (16 feet) of the rear of the PROCESSOR. Technical support and warranty of WATER SUPPLY PANEL is the responsibility of Kreonite. Water to a plumbed system must meet the following specifications: Flow rate: 3. 8-20 liters per minute (1-5 gallons per minute) Temperature: Hot- 59 C (120 F) minimum temperature. Practically, the water temperature should be adjusted to 35C (95 F) to minimize the time necessary to bring the PROCESSOR to operating temperature. Waste Water: A floor drain should be located convenient to the PROCESSOR. [. . . ] Waste Water: A floor drain should be located convenient to the PROCESSOR. The drain system should conform to local specifications for silver-laden bleach-fix, and stabilizer or waste water. Kodak will install a flexible drain TUBE to the PROCESSOR. [. . . ]