User manual SANYO FXCD-1350

[. . . ] OPERATING INSTRUCTIONS FXCD-1350 Fold Down Design Full Panel Detachable FM Stereo/AM Receiver Auto Reverse Cassette Player Compact Disc Player With CD Changer Controller ISO Mounting with Removable Trim Ring (English) OPERATING INSTRUCTIONS . 1~29 (Español) LIBRITO DE INSTRUCCIONES . 30~57 GB E SANYO MOBILE AUDIO MODEL FXCD-1350 LIMITED WARRANTY OBLIGATIONS In order to obtain warranty service, the product must be delivered to and picked up from an Authorized Sanyo Factory Service Center at the user's expense, unless specifically stated otherwise in this warranty. The names and addresses of Authorized Sanyo Service Center may be obtained by calling the toll-free number listed below. For product operation, authorized service center referral, service assistance or problem resolution, call CUSTOMER INFORMATION 1-800-421-5013 Weekdays 8:00 AM - 5:00 PM Pacific Time For accessories and/or parts not available from an authorized dealer, call PARTS ORDER INFORMATION 1-800-726-9662 Weekdays 8:00 AM - 5:00 PM Pacific Time THIS WARRANTY IS VALID ONLY ON SANYO PRODUCTS PURCHASED AND USED IN THE UNITED STATES OF AMERICA. [. . . ] Press the SCN button during play to start scan operation. To cancel scan, press the SCN button again. REPEAT MODE. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11 This operation makes it possible to listen repeatedly to a selection. "RPT" is displayed, the selection playing will continue until RPT is pressed again. Notes RPT/SCN may not operate properly if · A tape was recorded at a low level. · A tape has long, silent intervals. · A tape is a live recording. -14- CD OPERATION 4 1 6 5 78 9 LOADING AND EJECTING THE CD . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1, 2, 3 Press the OPEN button to open the door. 2 Insert a disc into the CD slot and the CD player will start. Press the eject button to eject a disc. 3 CAUTION · This CD player is not designed for 8 cm CDs. Please do not use an 8 cm CD nor 8 cm CD adaptor. · If the unit is already loaded with a CD, please do not attempt to insert another disc, which may result in damage to both of the discs and the unit. Note When the CD is ejected, "no" "Cd" will be flash alternately. SWITCHING TO CD MODE. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Press the CD / TAPE / CD-CH button to switch from radio or tape or CD changer* mode to CD player mode. When the CD mode is switched on while a disc is loaded, play resumes from the point at which play was stopped. When the entire disc has played, the unit returns to the first track and play resumes. The CD player continues playing the disc until the POWER button is pressed, the other mode is selected, or the disc is ejected. * If a CD changer is connected. -15- SKIPPING TRACKS. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5, 6 Press the > button to skip to the beginning of the next track. Press the < button to skip to the beginning of the track currently playing. Press the < button twice to skip to the beginning of the previous track. Press and hold the > or < button for more than 0. 5 seconds to search quickly (with sound) in the forward or reverse direction. When the button is released, the CD resumes normal play. SHUFFLE MODE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 This function plays the tracks on a CD in random order. Press the SHF button to begin shuffle play. [. . . ] · Connect to location drawing 10 A amperage or more. 3 +12V Accessory/Switched (Red) · Connect this wire to the terminal which receives power while the ignition switch is at ON or ACCESSORY position. · If the ignition switch does not have an ACC position, connect this wire to a +12V power terminal which receives power continuously. (Same as item 2. ) · Connect to location drawing 100 mA amperage or more. 4 Ground wire (Black) · Connect this wire to the vehicle chassis. 5 Power Antenna (Blue/Red) · Connect this wire to the control terminal of a Power Antenna. · When not using a Power Antenna, this wire is not connected. 6 Amplifier Turn On (Blue/White) · Connect this wire to an external amplifier. · When not using an external amplifier, this wire is not connected. 7 Sub-Woofer Cord (Monaural) · Connect this wire to an external sub-woofer amplifier. [. . . ]